Dishwasher Wire, Harness, Power Cord

This insulated wire lead carries electrical current between components, restoring reliable power routing in your appliance. It's a direct-replacement discrete wire used where a single conductor is required for safe operation. What it does:

• Provides a single insulated conductor to connect terminals or components
• Restores proper electrical continuity when a wire is damaged, burned, or disconnected
• Helps prevent shorts by maintaining insulation between conductors
• Suitable for low- to moderate-current wiring routes within the appliance

• One insulated wire lead as shown

• Disconnect power before inspecting or replacing wiring to avoid shock or injury
• Route the wire as the original, avoiding sharp edges and heat sources; secure with existing clips or ties
• Replace any damaged terminals, connectors, or fasteners; use correct crimps or solder joints per OEM practice

This replacement power cord supplies mains power to an electric range or oven, restoring reliable power delivery so the appliance can heat and operate normally. Designed as a direct-fit electrical cord for compatible models. What it does:

• Delivers line and ground connections from the wall outlet to the appliance electrical terminal
• Replaces a damaged, frayed, or burnt cord that can cause intermittent power or no power to the range/oven
• Helps eliminate loose connections that produce arcing, overheating, or tripping breakers
• Provides a correct, durable power connection when the OEM cord has failed

• Disconnect power at the main breaker or fuse box before starting work
• Access the appliance terminal block (usually behind a rear access panel) and reattach wires to the correct terminals
• Use proper wire connectors and tighten terminal screws to the manufacturer's torque; secure strain relief per the appliance design

The Power Cord is an OEM part for Whirlpool mixers. It provides the necessary electrical connection between your mixer and the power source, enabling your mixer to run reliably and safely.

Symptoms of a faulty power cord include:

• Intermittent power loss
• Exposed or frayed wires
• Loose connection or difficulty in maintaining power

A bad power cord can occur due to wear and tear, accidental damage, or electrical issues. If you experience problems such as intermittent power loss, exposed wires, or a loose connection, it may be time to replace the power cord.

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This wiring harness provides the electrical connection between control components, delivering secure signal and power routing for proper appliance operation. Replaces a worn or damaged harness to restore reliable connections and control response. What it does

• Routes power and control signals between internal components so controls and motors can operate
• Restores connection when frayed wires or broken plugs cause intermittent or no power to controls
• Helps stop failures caused by loose, corroded, or damaged wiring connections
• Prevents electrical arcing and poor contact from damaged connectors

• Disconnect all power (unplug appliance or switch off breaker) before starting any repair
• Handle connectors and wires carefully; avoid pulling on individual wires when removing/installing
• Match connector shapes and pin counts; ensure secure, fully seated connections
• Refer to the wiring diagram for routing and connector locations

This wiring harness assembly routes power and signals between refrigerator components so the appliance functions reliably. It replaces a damaged or worn harness to restore electrical connections and component control. What it does:

• Connects controls, sensors, lights, motors and other electrical components
• Carries power and low-voltage signals to enable normal refrigerator operation
• Helps resolve symptoms like intermittent or no power to components, lights out, or controls that don't respond
• Prevents shorting and poor connections caused by frayed or broken wiring

• Always disconnect power at the breaker or unplug the appliance before servicing
• Handle connectors gently; match connector shapes and colors to ensure correct connections
• Route harness along existing clips and channels; avoid sharp edges and heat sources