Estate Parts

Replaced the ice maker. The kit came with everything I needed to replace the ice maker. Parts that did not come with the kit were re-used from the old one. My Whirlpool refrig/freezer is an older model so the wiring harness that came with the kit was different from my existing. So instead of disconnecting the ice maker wiring harness from the freezer, I had to disconnect the harness at the ice maker. That was a b..... Anyway after about 20 minutes, finally unhooked the connector. I had... Read more

A YouTube video: https://www.youtube.com/watch?v=jIdtNdDXFDk , by a professional appliance repair company described replacement of the freezer drain pipe with Kenmore's (by Whirlpool) revised drain pipe. Ice buildup inside the freezer was caused by warm air beneath the freezer contacting cold air from inside the freezer the resulting condensation freezing and blocking the drain, causing the ice buildup inside. The revised drain tube functions as a p-trap to prevent cold/warm air interaction.... Read more

Took out the old and broken and replaced with new springs... Read more

Took apart the top of the stove and replaced ignitor Read more

It was easy to snap the broken part off, remove the end-piece of the runner to slide the wheel out, and replace with the new roller/part. Very easy and cost-effective! Thank you! Read more

I took the plastic vent piece off the front of the microwave & removed the charcoal filter & put the new one in. Made sure that while I had it open I cleaned all the built up grease out of it before closing it back up. Took the 2 grease filters from underneath the microwave & replaced with the new ones. Read more

Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot Read more

I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more

Order the correct harness from AppliancePartsPro.com and watch the video which was very helpful. Simple repair took only about 30 minutes. definitely saved myself a service call. Read more

Bought a new upper agitator/filter housing. Just slide it over the bottom agitator housing and put the cap from the old one on the new one. Takes maybe 3 minutes to do. The screen inside the lower part of the housing/filter holds it snug to the bottom housing and does not fly off during the spin cycle. Works great. Read more

Ordered your charcoal and stainless steel filters, checked out a YouTube video, et voila!! Slicker than a whistle! Thanks! Read more

Installed it according to video watched. Read more

Ordered the replacement pump seal kit from AppliancePartsPros. I watched the online how-to video on their website. The impeller was slightly stuck on the motor shaft due to age but overall was amazed at how easy it was to repair. Thanks AplianePartsPros! Read more

Took off the freezer door, took off the top hinge on the refrigerator door, replaced the handle, re-installed the top hinge and the freezer door. This is a two person job - one to remove the top hinge and replace the handle, while a second person holds the refrigerator door in place. Replacing the handle was easy. The most irritating part was figuring out what parts to order. The drawing of the refrigerator door (Drawing # 4) used to figure out what parts to order was not clear. I paid $8... Read more