Frigidaire Dishwasher Parts

Fix poor cleaning or drainage issues with this dishwasher impeller and seal kit. Restores water circulation for proper spray arm operation.

Creates a water seal in the drain path to prevent backflow and odors. Replace if cracked, clogged with detergent buildup, or deformed to restore drainage.

White timer control knob for dishwashers. Replaces broken, cracked, or missing knobs. Installs on the control shaft for a secure grip to set cycles.

Fix a broken or cracked detergent dispenser with this dishwasher dispenser assembly. Restores proper detergent release and door appearance.

Fix poor cleaning and incomplete draining with this lower impeller and seal kit. Restores water flow from pump to spray arms. Moderate DIY repair.

This is the support shaft that connects the lower spray arm to the pump housing at the bottom of the dishwasher tub. It acts as a pivot point, allowing the spray arm to rotate freely and distribute water evenly across dishes. Replace this part if the lower spray arm wobbles, falls off, or fails to spin properly, resulting in dishes that are not getting clean.

Fixes dishes not drying or coming out cold after the cycle. This heating element restores proper water heating and drying. Moderate DIY repair.

This pressure switch monitors the water level inside the dishwasher tub and signals the control board when the correct fill level has been reached. It uses air pressure from a small tube connected to the tub to detect water height. Replace this switch if the dishwasher overfills, does not fill with enough water, or displays fill-related error codes.

This is an electronic display control board for a dishwasher, and it includes mounting screws. It manages the user interface display and communicates cycle selections to the main control board. Replace this board if the display is blank, unresponsive, shows error codes, or if buttons no longer register when pressed.

Replacement dishwasher vent assembly that directs airflow inside the tub. Install when original vent is cracked, broken, or no longer opens and closes properly.

Fix a dishwasher that won't drain or has standing water with this drain pump assembly. Direct replacement for failed pumps. Moderate DIY repair.

Replacement dishwasher touch pad that installs on the control panel. Needed when the existing touch pad is cracked, peeling, unresponsive, or worn out.

This is a small bearing that fits onto the door hinge pin of a dishwasher. It allows the door to pivot smoothly when opening and closing, reducing friction and wear on the hinge assembly. Replace this bearing if the dishwasher door feels stiff, squeaks during operation, or does not stay open at the desired angle.

Seals the connection between your dishwasher pump and housing to prevent leaks. Replace when you notice water pooling or dripping. Confirm fit with your model.