Frigidaire Dishwasher Parts

Upper rack fence for dishwashers with 3-wire design. Replaces cracked, broken, or missing rack fences that no longer secure dishes properly.

Secures the spray arm to the dishwasher hub. Replace if the original nut is stripped, cross-threaded, cracked, or missing to properly mount the spray arm.

White timer knob for dishwasher control panel. Replaces broken, cracked, or missing original knob. Attaches to timer dial shaft for cycle selection.

If your dishwasher won't start or cycle selections aren't working, the selector switch may be faulty. This rotary control switch is straightforward to replace.

Houses and seals the dishwasher's filter screen to trap food debris and prevent recirculation. Replace if loose, cracked, or dishes remain dirty after cycles. Confirm fit by model number before ordering.

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

Fix a dishwasher that won't start, stops mid-cycle, or shows error codes with this control board. Moderately complex repair requiring basic tools.

Fix a dishwasher that won't advance cycles or stops mid-wash with a new control timer. Restores proper cycle timing and wash sequence operation.

Replace your dishwasher's stainless steel door panel if it's dented, scratched, or discolored. This outer cosmetic panel covers the door front.

Dishwasher macerator that grinds food particles for proper drainage. Replace if dishwasher won't drain or leaves standing water. Verify fit by model.

This cover, volute replaces the outer half of the dryer blower housing to protect the blower assembly and help direct airflow for efficient tumbling. Restores proper airflow path and helps reduce rubbing or contact with the blower wheel. What it does:

• Replaces the dryer blower housing cover that surrounds and shields the blower wheel
• Directs exhaust airflow from the blower to the exhaust duct for correct drying performance
• Helps prevent the blower wheel from rubbing on cabinet parts or allowing foreign objects to reach the blower
• Commonly used when the original cover is cracked, warped, or missing fastener locations

• One cover, volute

• Refer to your model's service manual or diagram for exact placement and screw locations
• Disconnect power and gas before starting any repair to avoid shock or injury
• Handle sharp sheet-metal edges carefully and use appropriate hand tools; reinstall all fasteners securely
• If rust, corrosion, or additional damaged parts are present, inspect the blower wheel and housing for proper fit

This sump housing collects and channels defrost and condensation water to the refrigerator drain system, helping prevent interior pooling and ice buildup. Replaces a cracked or clogged drain housing to restore proper water flow. What it does:

• Guides meltwater from the evaporator area into the drain tube and pan
• Helps prevent water pooling or leaks inside the fresh food or freezer sections
• Reduces ice buildup around the evaporator or under the freezer floor when functioning properly
• Works with the refrigerator's drain tube and pan as part of the defrost drainage path

• One sump housing

• Disconnect power to the appliance before starting work
• Remove food and shelves as needed; allow ice to fully melt before removing the old housing
• Inspect and clean the drain tube and surrounding seals when replacing the housing

Replacement mounting screw for dishwashers. Secures internal components and panels. Needed when original screws are stripped, missing, or damaged.