Frigidaire Refrigerator Parts

Replacement drip tray that sits beneath your refrigerator's ice and water dispenser. Catches drips and spills to keep the area clean and dry.

The Mullion is an OEM part for Frigidaire refrigerators. It is situated between the freezer and refrigerator doors to separate the two compartments. The mullion provides structure, sealing the doors against air and temperature leakage.

Causes of a bad mullion can include wear and tear over time, damage from frequent door opening and closing, or impact damage.

Symptoms of a bad mullion include:

• Air and temperature leakage between compartments
• Difficulty closing one or both doors securely
• Gaps or cracks seen around the mullion frame
• Scratches, dents or other physical damage

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Replaces cracked, broken, or missing trim piece on your refrigerator door handle. Covers mounting hardware for a clean finish and proper alignment.

Replace worn or broken freezer drawer slide rails. Restores smooth gliding and proper alignment. Includes left and right side guides for bottom-mount units.

Replacement actuator arms for refrigerator ice and water dispensers. Includes both paddles. Needed when arms are broken, cracked, or missing.

Fix a refrigerator with no power or a compressor that won't run by replacing the main power control board. DIY-friendly repair takes about 30 minutes.

Guide rail that supports and directs refrigerator drawers along their track. Replace when original is worn, cracked, or broken to restore smooth sliding.

The Water Filter Bypass is an OEM replacement part for Frigidaire refrigerators. It provides an alternative water supply route to bypass the refrigerator's built-in water filtration system. The bypass allows refrigerator water and ice dispensers to operate without water flowing through the installed filter cartridge. 

Causes of a malfunctioning bypass can include mineral buildup inhibiting proper operation of the bypass valve, worn seals or O-rings not providing a tight seal or physical damage.  

Symptoms include:

• Inability to bypass the water filter when needed  
• Leaks from the bypass area
• The filter bypass not functioning or engaging properly

This OEM replacement is also compatible with refrigerator brands like Electrolux, Gibson, Kelvinator, and select Kenmore models.

This condensate drain pan sits at the base of the refrigerator to collect defrost water and allow it to evaporate over the warm compressor, helping prevent floor puddles, moisture damage, and musty odors around the unit.

• Collects and holds defrost condensate from the drain tube (also called a drain pan or drip tray)
• Stages water to evaporate safely using compressor/condenser heat
• Replace if the pan is cracked, warped, missing, or leaking
• Common symptoms: water under/behind the refrigerator, damp flooring, or persistent musty odors near the bottom rear

• Unplug the refrigerator and pull it away from the wall; shut off water supply if connected
• Remove the rear lower access panel to reach the pan near the compressor
• Lift out the old pan; clear any debris from the drain outlet; transfer original mounting hardware if needed
• Seat the new pan level under the drain tube; ensure it's secure and reinstall the access panel

White refrigerator door handle that installs on the door exterior. Replace if your handle is cracked, broken, loose, or worn for restored grip and appearance.

Kickplate grille that covers the bottom front of your refrigerator. Replace if cracked, broken, or missing clips cause it to fall off repeatedly.

Catches drips and splashes at the base of your refrigerator's ice and water dispenser. Replace this tray if it's cracked, broken, or missing.

Fixes refrigerator not cooling, dispenser won't stop running, or unresponsive controls. Main control board regulates temperature and defrost cycles.

Refrigerator not cooling or freezing over? A failed evaporator fan motor stops air circulation. Straightforward DIY repair restores proper cooling.

Installs in your refrigerator's filter housing to deliver cleaner, better-tasting water and ice. Replace every 6 months to restore flow and maintain performance. Confirm fit with your model number.

White plastic end cap that holds the door retainer bar in place on refrigerator door shelves. Replaces broken or missing supports that cause racks to fall.