General Electric Dryer Parts

The Water Valve is an OEM part for GE electric dryers. Located near the bottom of the machine, it controls water flow into the condenser system during moisture-sensing cycles.

The moisture sensing function uses this valve to introduce precise amounts of water vapor into the exhaust air stream periodically. This allows the condenser to capture moisture readings accurately and determine optimal cycle time based on humidity levels. 

Causes of failure include mineral buildup restricting flow, worn seals enabling leaks, or misaligned internal components hindering valve movement.

Symptoms of a faulty water valve are: 

• Loss of moisture sensing ability
• Incomplete or improper readings affecting cycle times  
• Water leaks from the valve area
• Failure to inject water vapor as needed

This part is also compatible with some Kenmore models using GE components.

Size: 8 - 18 ab.

Covers unused hinge or mounting holes on refrigerator doors after reversing door swing. Replaces cracked, missing, or damaged plugs for a clean finish.

Single replacement screw for securing dryer panels and internal components. Replaces lost, stripped, or damaged screws to restore proper fastening.

Dryer won't start, won't heat, or displays errors? The main control board manages all dryer functions. Common fix for no-start and timing issues.

This timer is the electromechanical control that sequences a washer's wash, rinse and spin cycles, restoring proper cycle advancement and timing for affected machines. Use this direct-fit replacement to regain reliable cycle control and predictable operation. What it does:

• Rotates through and switches washer cycle stages (fill, agitate, drain, spin) to control timing
• Replaces a worn or failed timer that causes cycles to stop, not advance, or skip functions
• Restores timed operation when a washer won't complete cycles or starts intermittently
• Interfaces with controls and motors to coordinate cycle transitions

• Disconnect power before attempting service to avoid shock or injury
• Access may require removing the control panel or console
• Retain all mounting hardware and note wiring positions; replace exactly as removed

Fix a dryer door that won't stay closed or latch properly with this door latch body. Common repair for doors that pop open during cycles. Easy install.

Terminal block mounting screw for dryers and washer dryer combos. Secures the terminal block to the dryer frame. Replace if stripped, missing, or damaged.

This is a replacement mounting screw used to secure appliance panels and components, restoring proper fit and reducing vibration or rattling. Use it to replace a missing or damaged fastener for a secure repair. What it does:

• Secures panels, trim, brackets, or small components in place
• Restores proper panel alignment and reduces rattling or vibration
• Replaces stripped, missing, or corroded screws that cause loose parts
• Helps maintain electrical and mechanical connections by holding parts steady

• Turn power off and unplug the appliance before beginning any repair
• Use the matching driver or bit to avoid stripping the screw head
• Replace only with the same type and size screw for a proper fit
• Inspect surrounding parts for wear

This gas diffuser directs and evens the burner flame for reliable cooking performance. It helps stabilize heat distribution so burners light and heat more consistently across cookware. What it does:

• Spreads and evens gas flame to reduce hot spots and uneven cooking
• Helps stabilize burner ignition and maintain consistent flame shape
• Prevents direct flame contact with surrounding components
• Addresses symptoms like uneven heating, unstable flame, or partial burner operation

• One gas diffuser

• Turn off the gas supply and unplug the appliance before servicing
• Use basic hand tools; avoid overtightening or distorting the part
• If corrosion or sealed fasteners are present, replace affected hardware and check surrounding components

Ceramic terminal insulator protects heating element electrical connections in dryers. Replace if cracked, broken, or missing to restore secure insulation.

Stainless steel #8 x 5/8" screw for dryer door and panel assembly. Replace missing, stripped, or corroded screws to secure components properly.

Plastic plug that covers unused screw holes on dryer panels for a clean appearance. Replace when cracked, missing, or worn to protect openings.