General Electric Dryer Parts

Secures the front panel on dryers. Replace if the panel is loose, rattling, or won't stay in place. Confirm fit with your model number before ordering.

Dryer won't turn off or advance cycles? This mechanical timer controls cycle selection and transitions. Moderate DIY repair restores automatic shutoff.

This control component allows selection between four different heat settings and is located on the dryer's control panel. Replace it when heat settings don't change, the switch feels loose or broken, or clothes aren't drying at the selected temperature.

Dryer won't start, won't heat, or displays errors? The main control board manages all dryer functions. Common fix for no-start and timing issues.

A replacement pan head screw used to fasten appliance panels and components. Its standard #8 coarse thread and 3/8-inch length secure trim, brackets, and small assemblies for stable operation. What it does:

• Fastens panels, brackets, and small parts in household appliances
• Replaces stripped, rusted, or missing #8-18 pan head screws
• Restores secure mounting where vibration or wear caused looseness
• Works with sheet-metal or threaded inserts designed for #8-18 screws

• Disconnect power to the appliance before beginning any repair
• Use the correct #2 Phillips or compatible driver to avoid cam-out
• Thread in straight and tighten until snug; avoid over-tightening to prevent stripping
• Keep small screws away from children and dispose of old fasteners safely

Mounting screw for washers, dryers, and pedestals. Replaces broken, stripped, or missing screws that secure panels and components. Essential hardware.

Size: 8-18 b.

Drum roller assembly for dryers. Mounts to the rear panel to support smooth drum rotation. Replace if worn, squeaking, cracked, or causing wobble.

Replacement idler spring for dryers. Provides tension to keep the idler pulley and drive belt aligned. Replace if spring is stretched, broken, or worn.

Complete lint trap duct assembly for your dryer. Connects the lint filter housing to the blower. Replace if cracked, damaged, or leaking lint.

This molded wire tie standoff provides a secure anchor point for a cable tie to hold wiring and harnesses away from moving parts and hot or sharp surfaces, helping reduce wear and electrical risk. Fits common HVAC and appliance wiring panels. What it does:

• Anchors wire ties to the appliance cabinet or chassis so harnesses stay routed and secured
• Prevents wires from rubbing on sharp edges, hot components or moving parts
• Helps stop intermittent electrical issues from loose or vibrating connections
• Reduces noise from loose wiring that can vibrate during operation

• One wire tie standoff

• Disconnect power before servicing the appliance to avoid shock or damage
• Mount in the original standoff hole or approved panel location; secure a cable tie through the top loop to hold the harness
• Use the correct fastener or snap method for your model—do not force or overtighten
• If routing or attaching multiple wires, verify clearance from heating elements and moving parts

Start button switch for dryers and washer-dryer combos. Replaces worn, cracked, or unresponsive buttons. Mounts on control panel for cycle activation.

Secures the belt switch to the dryer motor. Replaces damaged, cracked, or broken mounting brackets. Direct-fit assembly for safe dryer operation.

Caster wheel assembly for dryers. Installs at the base to provide mobility and stability. Replace if cracked, broken, or wheels no longer roll smoothly.

Seals your dryer door to prevent heat loss and improve drying efficiency. Replace if torn, cracked, or no longer sealing properly. Confirm fit with your model.