General Electric Dryer Parts

Heat deflector for dryers. Directs heated air properly through the drum. Replace if cracked, warped, or missing to restore efficient airflow distribution.

A lower-rack lifter that secures and guides the dishwasher's bottom rack for smooth movement and correct positioning. Restores proper rack height and alignment so dishes load, wash, and drain without interference. What it does:

• Supports and raises/lowers the lower dish rack to the correct operating position
• Keeps the rack aligned on its track to prevent binding or rough movement
• Reduces rack rubbing against tub walls and helps ensure proper spray-arm clearance
• Commonly replaced when the rack drops, won't stay level, or moves unevenly

• Disconnect power and turn off water supply before servicing dishwasher
• Remove lower rack to access and replace the lifter; no special tools typically required
• Verify proper seating on the rack guide and smooth operation before returning unit to service
• If other rack components are damaged, inspect for worn wheels or track issues

Heat shield baffle that mounts to the back of the dryer drum. Replace if cracked, broken, or missing to protect drum components from direct heat exposure.

White control panel touch pad assembly for your dryer. Replaces worn, cracked, or unresponsive touch pads. Installs on the control console exterior.

This back assembly is the factory-style rear cabinet panel that protects and supports internal components. It restores the appliance's structural rear cover and helps keep internal parts safe from debris and damage. What it does

• Replaces a damaged or missing rear cabinet panel to protect motors, wiring and electronics
• Restores mounting points for components that attach to the back of the cabinet
• Helps reduce air flow loss and limits access to internal parts that can cause shorts or damage
• Common symptoms: visible dents or holes in the back panel, loose or rattling rear cover, or exposed components

• Disconnect power to the appliance before beginning any repair
• Installation typically requires basic hand tools; handle edges carefully
• Keep screws and fasteners from the original panel for re-use unless replacements are supplied

Replace your dryer's control panel touch pad assembly when buttons are unresponsive, cracked, or worn. Installs on the top panel for cycle selection.

Left-hand endcap for dryer drum assembly. Secures and supports the drum end. Replace if cracked, broken, or missing to restore proper drum support.

Secures and stabilizes the adjustable leveling leg on your dryer. Replace if the bracket is cracked, broken, or missing to keep your dryer level on uneven floors.

Replaces worn, cracked, or missing dryer control knob assembly. Restores manual control of cycle and temperature settings on your dryer control panel.

This is a safety device installed in the gas supply line of a gas dryer that restricts gas flow in the event of a leak or line disconnection. It helps prevent dangerous gas accumulation by limiting the amount of gas that can escape. Replace the leak limiter if your dryer has difficulty igniting, produces a weak flame, or if a gas technician identifies it as faulty during a safety inspection.

Meters gas flow to the dryer burner. Replace if damaged, clogged, or when converting between natural gas and LP. Installs at the burner assembly.

Ground strap assembly connects drum shaft to dryer frame for electrical safety. Replace if damaged, corroded, or causing startup squealing noise.

Fix a dryer door that won't stay closed with a new door catch. This latch keeps your dryer door securely shut during operation. Easy 15-minute repair.

Sound dampening insulation package for dryers. Installs inside cabinet to reduce noise and vibration. Replace if damaged, worn, or missing insulation.

Protective cover for your dryer's terminal block electrical connections. Replace if cracked, broken, or missing to safely cover wire terminals.