General Electric Dryer Parts

Replacement lock button for dryer control panel. Restores panel locking function when original button is cracked, broken, or missing from use.

Replace your dryer's display window lens if it's cracked, scratched, or missing. This clear protective cover installs over the control panel display.

Dryer won't advance through cycles or stops mid-cycle? This timer control regulates your dryer's cycle progression. Moderate DIY repair for most models.

Aligns and supports your dryer door for smooth closing and secure latching. Replace if cracked, broken, or missing to eliminate gaps and restore fit.

Side vent kit for dryers that redirects exhaust airflow to the side instead of the rear. Needed when rear venting isn't possible due to space constraints.

Secures the ground wire to the dryer cabinet for safe electrical connection. Replace if missing, stripped, or corroded to restore proper grounding.

This small mounting screw secures panels and trim on compatible GE appliances, restoring a solid, vibration-free fit. Use it to replace a missing, stripped, or damaged fastener and keep parts aligned and secure. What it does:

• Fastens panels, trim, or small components to the appliance frame
• Replaces missing or damaged screws that cause loose or rattling parts
• Restores secure attachment when threads are stripped or worn
• Helps maintain proper alignment to prevent noise and component wear

• Use the correct screwdriver size to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread damage
• Disconnect power or move the appliance to a safe position when accessing internal panels
• Consider a replacement clip or insert as recommended by the manufacturer

Metal bracket that secures the dryer motor and blower assembly in place. Replace if your mounting bracket is cracked, broken, or causing loose components.

Support plate that mounts behind the dryer console to secure the electronic control board. Replace if cracked, broken, or missing to properly reinstall control.

Installation and care guide manual for your dryer. Reference document for proper setup, maintenance instructions, and operating guidelines. Replace missing or damaged manuals.

Replacement use and care manual for your dryer. Provides operating instructions, maintenance guidelines, and troubleshooting tips for proper appliance use.

The oven control and overlay assembly are installed directly in the front of the main console of the oven. They contain the control interface of the appliance. When the overlay assembly and control interface malfunction, normally, the backlight goes out behind the console. The user is unable to see any controls or function information. This malfunction can be caused by electrical short or external damage. It's possible a fuse could be the problem, and a voltage tester can give you a clear indication of where the problem lies. Begin the installation by unplugging the oven first. Using a screwdriver, unthread the screws around the perimeter of the main user interface. This will allow the casing around the console to come off. On the rear of the oven, remove the screws holding the back panel in place until the control board can be seen. Unscrew the control board assembly from the control overlay assembly. Repeat these steps in reverse with the new part.This GE oven control and overlay assembly is a genuine OEM product sourced directly from the manufacturer. The listed product is sold individually. This part is compatible with GE, Kenmore, HotPoint, RCA, and Kenmore.

Wire harness for dishwashers. Replaces damaged, frayed, or burnt wiring connections inside your appliance. Essential when harness is broken or worn.