General Electric Dryer Parts

Replacement outer glass panel for dryer doors. Restores visibility and finished appearance when original glass is cracked, chipped, or scratched.

Supports and helps rotate the dryer drum smoothly. Replace when roller is worn, damaged, or causing friction. Installs on the drum support system.

Metal bracket that secures the dryer motor and blower assembly in place. Replace if your mounting bracket is cracked, broken, or causing loose components.

Fix a dryer that won't start or drum won't turn with a new motor assembly. Moderate DIY repair requiring drum removal and electrical testing.

Support plate that mounts behind the dryer console to secure the electronic control board. Replace if cracked, broken, or missing to properly reinstall control.

Secures the ground wire to the dryer cabinet for safe electrical connection. Replace if missing, stripped, or corroded to restore proper grounding.

Installation and care guide manual for your dryer. Reference document for proper setup, maintenance instructions, and operating guidelines. Replace missing or damaged manuals.

Replacement use and care manual for your dryer. Provides operating instructions, maintenance guidelines, and troubleshooting tips for proper appliance use.

The oven control and overlay assembly are installed directly in the front of the main console of the oven. They contain the control interface of the appliance. When the overlay assembly and control interface malfunction, normally, the backlight goes out behind the console. The user is unable to see any controls or function information. This malfunction can be caused by electrical short or external damage. It's possible a fuse could be the problem, and a voltage tester can give you a clear indication of where the problem lies. Begin the installation by unplugging the oven first. Using a screwdriver, unthread the screws around the perimeter of the main user interface. This will allow the casing around the console to come off. On the rear of the oven, remove the screws holding the back panel in place until the control board can be seen. Unscrew the control board assembly from the control overlay assembly. Repeat these steps in reverse with the new part.This GE oven control and overlay assembly is a genuine OEM product sourced directly from the manufacturer. The listed product is sold individually. This part is compatible with GE, Kenmore, HotPoint, RCA, and Kenmore.

Wire harness for dishwashers. Replaces damaged, frayed, or burnt wiring connections inside your appliance. Essential when harness is broken or worn.

Dryer foam gasket seal that prevents air leaks and ensures proper drying efficiency. Replace when worn, compressed, or damaged to restore performance.

White dome plug insert for dryer control panel or cabinet. Replaces cracked, broken, or missing plastic dome plugs. Snaps into place to cover holes.

White plastic plug insert for dryer installation. Replaces cracked, broken, or missing plug components. Direct fit part for secure connection.

White rotary control knob for dryer timer or cycle selector. Replaces cracked, broken, or missing knobs on control panel. Direct replacement part.

Right-hand mounting bracket for dryers. Secures internal components in place. Replace if cracked, bent, or broken to restore proper support and alignment.

Replacement lamp cover for your dryer's interior light. This plastic cover protects the bulb and lens. Order now if yours is cracked, broken, or missing.