General Electric Range / Cooktop / Oven Valve

This oven safety valve controls natural gas flow to the bake/broil burners so the oven heats reliably and shuts off gas when not called for. Replaces a worn or failed valve to restore safe oven operation. What it does:

• Opens and closes gas supply to the oven burners when heat is requested
• Prevents unwanted gas flow when the oven is off
• Common replacement for ovens that won't heat or have intermittent ignition
• Works with the oven's temperature control and safety systems

• One oven safety valve (natural gas)

• Turn off electrical power and shut off the gas supply before starting work
• After installation, check all gas connections for leaks with an approved leak detector and follow local codes

This gas valve controls gas flow to the burners and oven, restoring reliable ignition and consistent heat when the burner won't light or the oven won't heat properly. Designed as a direct replacement part. What it does:

• Regulates gas supply to the oven and cooktop burners for proper ignition and consistent flame
• Commonly replaces valves that cause burners not to light or the oven to not maintain heat
• Helps stop irregular gas flow that can lead to weak or fluctuating flames
• Works with the appliance's safety and control systems to open and close gas flow as commanded

• One gas valve as shown

• Shut off the gas supply and disconnect power before starting any repair
• Only install on compatible appliances;
• Tighten gas fittings to the manufacturer's torque spec and test with a leak solution

This safety valve assembly controls the flow of gas to the oven or range burner, restoring safe operation and allowing the appliance to heat when the valve opens. It replaces a faulty shutoff/regulator valve to help address heating issues. What it does:

• Regulates and shuts off gas flow to the burner/oven when required for safe operation
• Commonly used when the oven or burner will not light or stays unlit
• Can stop gas flow if a valve or regulator fails, reducing risk of unregulated gas release
• Works with the appliance's ignition and safety systems to allow normal heating once operating correctly

• One safety valve assembly as shown

• Shut off gas supply and power before starting; follow appliance-specific safety procedures
• Only install on compatible models and use proper fittings; verify orientation and connections match the original
• Check all gas connections for leaks after installation using an approved leak-detection method

This valve kit is the replacement assembly that controls fluid flow to the appliance's internal components, restoring proper operation and helping stop flow-related failures. It replaces a worn or damaged valve to return reliable performance. What it does:

• Regulates flow through the appliance so water or fluid reaches the correct component
• Re-establishes proper filling, dispensing, or flow when a valve has failed
• Stops intermittent or no-flow symptoms that can prevent normal appliance function
• Helps address leaks or drips originating at a faulty valve connection

• Disconnect power and shut off the water or fuel supply before beginning service
• Follow the appliance service manual and use OEM-compatible fittings and seals
• Inspect hoses, connectors and mounting hardware; replace any damaged parts
• After installation, restore supply, check for leaks and verify proper operation

This switch valve assembly replaces the appliance's combined valve and switch module to restore controlled on/off operation of the valve. It provides a direct replacement for the original electromechanical valve switch to help the appliance operate reliably. What it does:

• Acts as the combined valve and switch module that controls flow when signaled by the appliance control
• Reestablishes reliable electrical switching to open and close the valve under normal operation
• Commonly used when the valve fails to actuate or when intermittent valve switching occurs
• Helps eliminate symptoms such as failure to start flow, no actuation, or inconsistent on/off cycling

• Disconnect power to the appliance before servicing; if the valve controls gas or water, also shut off supply
• Take photos or mark wiring before disconnecting to ensure correct reconnection
• Handle the part by mounting points; avoid stressing wiring or connectors