General Electric Refrigerator Touch Pad

This nameplate recess assembly secures and positions the appliance's front nameplate, keeping the emblem recessed and aligned for a clean, finished appearance. It replaces a cracked, loose, or missing nameplate pocket to restore the factory look. What it does:

• Provides the molded pocket that holds the brand nameplate on the appliance front
• Keeps the nameplate flush and aligned to prevent rattling or falling out
• Restores appearance when the original recess is cracked, broken, or deformed
• Helps protect the nameplate edge from damage during normal use

• One nameplate recess assembly

• Installation typically requires removing the front panel or trim;
• Use appropriate hand tools; avoid excessive force that could crack surrounding panels
• Power off and unplug the appliance before beginning any disassembly to avoid electrical or injury hazards
• If fasteners or clips are missing or damaged, replace them with OEM-specified hardware

This nameplate recess assembly is the molded trim piece that holds and protects the appliance's front badge and control label, restoring a clean, finished appearance. It replaces a cracked, loose, or missing nameplate pocket to secure the ID plate. What it does:

• Provides a recessed mounting pocket for the appliance nameplate or badge.
• Covers and protects mounting hardware and underlying fascia from dirt and damage.
• Restores proper fit-and-finish where the original recess is cracked or broken.
• Helps prevent the nameplate from rattling or falling out during use.

• Disconnect power to the appliance before starting any work.
• Typically secures with clips or screws; use appropriate hand tools and avoid overtightening.
• Handle the trim carefully to avoid scratching the finish; replace any broken retainers.

This nameplate recess assembly secures and seats the appliance nameplate on the control panel area for a clean, finished appearance and proper identification. It restores proper fit and prevents the nameplate from rattling or falling out. What it does:

• Provides the mounting pocket and support for the appliance nameplate on the control panel
• Keeps the nameplate flush and aligned for a factory appearance
• Stops movement or vibration that can cause rattling or partial detachment
• Helps protect the nameplate edges from catching or damage during use

• Disconnect power to the appliance before starting any work
• Remove the necessary trim or control panel screws to access the nameplate area
• Align the recess assembly tabs with the panel openings and snap or fasten into place; retain any original clips or screws
• Handle parts carefully to avoid scratching finishes or damaging the nameplate