Ignition Controls

This ignition module generates the electrical spark needed to ignite the fuel-air mixture in a small engine, typically found in string trimmers and similar outdoor power equipment. It converts low-voltage energy into a high-voltage pulse sent to the spark plug. Replace this module if the engine fails to start, misfires, stalls intermittently, or produces no spark at the plug.

Ignition module for gas leaf blowers and line trimmers. Mounts near the flywheel to generate spark. Replace if cracked, corroded, or failing to start.

This electronic module creates the electrical spark needed to start the line trimmer's engine, typically mounted adjacent to the flywheel and spark plug. Replace when the engine won't start, has difficulty starting when warm, or runs inconsistently despite proper fuel mixture and clean air filter.

This part is an ignition module that is used on chainsaws. An ignition module is a component of the engine ignition system. This part connects the spark plug to the engine and supplies power that helps create the spark which starts the engine.A new ignition module may be needed if the original is cracked, broken, or damaged in any way. The ignition module may become damaged or worn after normal use over a period of time. If this is the case, the ignition module will need to be replaced for the chainsaw to turn on. Remember to wear gloves when operating or performing care and maintenance on any outdoor power equipment.This ignition module is a genuine Husqvarna part. It is sold individually. This specific ignition module is compatible with chainsaws that are manufactured by Husqvarna, Poulan, and Jonsered.

This is a genuine ignition module for Husqvarna engines on select outdoor lawn equipment. The ignition module includes the ignition coil and spark plug connector in a single piece. This module is used to transfer the electric charges from the flywheel magnets. This ignites the fuel-air mixture in the cylinder and creates the combustion that powers the engine. Over time, the ignition module can become worn or the spark plug connector can snap off or get damaged, causing a need for replacement. Without a properly functioning ignition module, the engine will not be able to start. This OEM ignition module is manufactured to exact standards for use in Poulan and Husqvarna string trimmers. It is a replacement for the original part and is sold as an individual unit. The spark plug and other parts and hardware will require an additional purchase. To replace this part, allow the engine to cool and disconnect the old ignition module from the spark plug. Then, detach the other side of the module and replace it with the new part. Reconnect the spark plug and the job is done. Be sure to allow the engine to cool and wear gloves when performing this repair.

This genuine replacement ignition module is part of the starting system in select models of gas string trimmer/edger units. It connects the spark plug to the engine and supplies the electric current to generate the spark for ignition. In the event that the module wears out or becomes defective, the engine may fail to start. With a faulty ignition module, it will be difficult to operate equipment if it works at all, which is why an immediate replacement with an OEM part like this is necessary. This genuine OEM ignition module is manufactured by Husqvarna and compatible with select trimmers from Poulan, Weed Eater, and Husqvarna. This unit includes the ignition module, the rubberized wire, and the spark plug boot or cap. Hardware and other components are not included. It may be a good idea to replace the spark plug when replacing the ignition module if it has not been replaced recently. Be sure to wear gloves and allow the engine to cool before doing any repairs on the ignition or other engine components. Be sure to disconnect the power supply before beginning any repairs for safety, as well.

These keys start and operate your lawn tractor's engine through the ignition switch, typically located on the dashboard or control panel. Replace when keys are lost, damaged, or worn to the point where they don't turn smoothly in the ignition.

Ignition module for tillers and edgers. Mounts to the engine block to control spark timing. Replace if cracked, damaged, or causing weak spark output.

This is a genuine ignition module, also known as an ignition coil, that is designed to be used on select line trimmers. The ignition module is what connects the spark plug to the machine and is responsible for creating the spark and carrying that power back to the engine to power the unit. if the ignition module fails, the engine will not be able to start. It could start and stop, or it could fail to start entirely. Either way, replacing the ignition module will resolve the issue in most cases and can be done with this OEM part. Since it's attached to the spark plug, it's a good idea to inspect the module during regular spark plug replacement and other maintenance to check for damage. The ignition module is made from durable metal and rubber materials and is sold as an individual part. It will require a screwdriver and socket set to replace the part. Be sure to wear gloves to protect the hands and disconnect the power for safety before doing any work on electrical components like this.

Replacement ignition coil for front-tine tillers and cultivators. Installs on the engine to generate spark. Replace if cracked, damaged, or missing.