Ikea Refrigerator Parts

White plastic hinge thimble that fits over the door hinge pin on refrigerator doors. Replaces cracked, worn, or missing thimbles affecting door alignment.

Secures water filter for proper filtration and flow to dispenser or ice maker. Replace if cracked, leaking, or filter won't seat properly. Verify fit.

Fix a warm fridge or freezer that won't stay cold with a new evaporator fan motor. This motor circulates air over cooling coils. Easy DIY repair in under an hour.

Ice dispenser not working or auger won't spin? This drive shaft transfers motor power to dispense ice. Easy DIY repair with 4 screws takes under an hour.

Fix freezer icing and blocked vents with this defrost heater. Melts frost buildup on evaporator coils during defrost cycle. 30-minute DIY repair.

The Door Closure Cam is an OEM replacement part for Whirlpool refrigerators. It is a small lever located inside refrigerator doors that engages the latch bolt when closing. The closure cam ensures doors are securely fastened shut to maintain optimal cooling temperatures.

Causes of a bad closure cam can include worn or loose mounting points preventing engagement, cracked or broken lever components, or door latch mechanisms that inhibit full closure.

Symptoms of a bad door closure cam include:

• The refrigerator door not closing fully or latching securely
• Cool air escaping around door edges
• Higher energy bills from excessive compressor run times
• Interior condensation or frost buildup from improper seals

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and some Kenmore models

This gray magnetic door gasket creates an airtight seal around the refrigerator or freezer door to maintain proper internal temperatures. It is a flexible rubber strip that attaches along the perimeter of the door. Replace this gasket if you notice warm spots inside the unit, excessive frost buildup, the compressor running constantly, or if the gasket is visibly torn, cracked, or no longer sealing tightly when the door is closed.

Refrigerator door gasket creates an airtight seal to maintain temperature and efficiency. Replace if cracked, torn, or loses compression. Confirm fit.

Fix a refrigerator that's not cooling properly with this condenser fan motor. Replaces worn motors causing poor heat exchange. Video guide included.

Fix frost buildup and grinding noises with a refrigerator defrost heater. Melts ice on evaporator coils. Video guide included for easier installation.

Ice bin overflowing or ice maker won't stop making ice? The shut off arm signals when to stop production. Simple install in under an hour.

Note: The Fan Motor with Harness also includes the Defrost Thermostat and Thermistor.

The Evaporator Fan Motor is an OEM part for Whirlpool refrigerators. This motor is responsible for circulating cold air throughout the refrigerator and freezer compartments, ensuring uniform temperature and efficient cooling. It helps maintain the desired temperature by moving air across the evaporator coils and distributing it evenly.

Causes of a bad evaporator fan motor can include electrical failures, worn-out bearings, or damage due to ice buildup. Regular wear and tear from continuous operation can also lead to motor failure over time.

Symptoms of a bad Evaporator Fan Motor include:

• The refrigerator or freezer not cooling properly
• Unusual noises coming from the fan area
• Frost buildup in the freezer compartment
• The fan not running when the refrigerator is on

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Magnetic refrigerator door gasket seals cold air inside. Replace when warm air leaks in or frost builds up. Verify fit with your model number.

Fixes refrigerator not cooling, compressor not running, or frost buildup. This control board manages cooling cycles and temperature regulation.

The Water Reservoir Tubing is an OEM replacement part for Whirlpool refrigerators. It is a flexible plastic tubing that replaces the water reservoir and holds the water for the ice maker and dispenser.

Causes can include cracks from heat or cold exposure over time, punctures from sharp edges during installation, or deterioration of plastic tubing that impacts integrity.

Symptoms of bad water reservoir tubing include:

• Inaccurate or inconsistent ice production
• Leaks or water spills near the reservoir or ice maker
• Kinks or ruptures in the tubing that obstruct water flow
• Mineral buildup that clogs or restricts the line

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and some Kenmore models.

Note: As per manufacture this is no longer a tank. The tank style has been updated with coiled tubing.

Cracked or missing ice maker cover exposing internal components? This protective cover shields the ice maker assembly. Simple DIY install in minutes.