Kenmore / Sears Refrigerator Parts

Replaced the damper control. It took only 10-15 minutes. Since replacement, the clicking noise has stopped. Very happy with the result. However, want to share that there was probably nothing wrong with the original damper other than the original faulty design. The flap opens and closes and believe the clicking noise was the result of plastic against plastic. Noticed the new damper control is exactly the same as the original except that one of the flap sides now has a thick piece of rubbery... Read more

• Won't start
• Fridge runs too long
• Frost buildup
• Fridge too warm

After reviewing a number of testimonials and your videos from your APP.com site I determined my most likely problem was either the defrost heater, thermostat, timer or possibly all three. The real challenge now began. Getting to the specific parts with my specific model number was a real challenge. It was not as easy as removing the light guard and 5 screws since my model had two Track Cant Shelf vertical rails restricting the removal of the back panel. Also, these rails could not be removed... Read more

Re placed the water inlet valve. Read more

Put filter in and turned Read more

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

I ordered new parts from your company for my refrigerator. These were easy parts to replace and did not require tools. I was most grateful in being able to order those parts by telephone from your company. This process was surprisingly easy and did not require a long wait to speak to a representative. The persons I spoke with were polite, efficent and very competent. The parts got to me very quickly in well packed boxes. I though this process would be an ordeal and it was the opposite. This was... Read more

I ordered three parts for my fridge. The entire process was so easy! I entered my model number and quickly found the parts I needed! Submitted the order and the parts arrived the Next Day! I was very happy! Read more

Watched video by AppliancePartsPros.com and fully understood what had to be done. This company is an excellent example of how a company should be run. Very helpful and professional team support. A model for a company that wants to offer customer service! Read more

Replace glass took no time at all less then 5 minutes no major tools required Read more

Replaced water valve and ice maker Read more

A bit of online research and some component testing narrowed my issue down to either a faulty ice maker or a bad supply valve. Appliance Parts Pros had both of these, at reasonable prices, so I purchased and replaced both items. I recommend watching online videos to get a sense of what to do, and how to go about doing it. The repairs were relatively easy, other than this being a bottom freezer model hence the ice maker was difficult to access: I removed the freezer door (four screws) to get... Read more

Given all the symptoms, we figured that the control board went out. First, unplug the refrigerator. The control board was easy to access by removing a panel on the back of the fridge. I unplugged all the connectors and used a putty knife to release the board from the plastic retaining clips. There was some browning on the underside of the board and the back of the refrigerator that suggests one of the capacitors on the board blew. Install the new board by pressing it into the retaining clips... Read more

• Leaking
• Not dispensing water

Installed a new water valve assembly and a new ice maker assembly. Read more

I ordered the part online, which arrived in a few days. Installation took about 60 seconds. Read more

The bar retainers just snapped in and the door handle can be replaced with three screws. Took about 5 minutes total. Read more

I had a slow leak at the water inlet valve where the water line from the filter assembly connected to the water inlet valve. I determine that the water line had scratches in it which caused it to not seal. Had to buy the entire reservoir and filter assembly to get that water line. The replacement was smooth. It took about 30 minutes to swap out and it fixed the leak. Read more