Kenmore / Sears Refrigerator Relay, Overload, Capacitor

Compressor won't start or refrigerator not cooling? This relay and overload kit restores compressor function. DIY-friendly, most installs under 15 minutes.

Fixes refrigerator not cooling or compressor not starting. This starter relay energizes the compressor start winding for reliable operation. DIY repair.

Fix a refrigerator that clicks but won't start or runs warm. This compressor start relay restores reliable startup. Simple DIY repair in under an hour.

Fixes a refrigerator that won't cool while lights and fans work. This thermal overload protector prevents compressor damage. DIY install in 15 minutes.

Start relay for refrigerator compressors that helps the compressor begin running at power-up. Replacing a failed relay can restore normal starting behavior and resolve common startup symptoms. What it does

• Provides the initial start current path to the compressor during startup.
• Allows the compressor to reach running speed, then drops out once the motor is running.
• Common symptoms a bad relay may cause: compressor clicking, humming without starting, intermittent cooling or frequent cycling.
• Installed as the electrical component used only on compatible compressor assemblies.

• Disconnect power to the appliance before servicing to avoid electrical shock.
• Access the relay at the compressor; remove and replace the relay only after confirming diagnostics.
• Dispose of the old electrical part per local regulations.

Refrigerator won't start or stops running? A failed capacitor disrupts motor circuits. This film radial capacitor restores voltage stability and operation.

This compressor overload is a thermal/protective device that helps prevent compressor damage by cutting power when the motor overheats or draws excessive current. It restores normal operation once conditions return to safe levels. What it does:

• Protects the refrigerator compressor from overheating and electrical overloads
• Works with the compressor start relay to help the motor start and run properly
• Common symptom linkage: replaces a failed overload when the compressor hums but won't start
• Stops compressor cycling or prevents repeated trips that cause cooling loss

• One compressor overload (single piece as shown)

• Disconnect all power before replacing to avoid shock or injury
• Handle terminals carefully and reconnect matching terminal positions
• Replace only with the same part number or equivalent
• If compressor still won't start after replacing the overload, check the start relay and compressor condition.

Fix a clicking compressor or refrigerator that won't cool. This start relay and overload assembly restores compressor startup. DIY repair in 10-15 minutes.

Fix a refrigerator that hums and shuts down or won't start with this compressor overload protector. Simple DIY repair that restores safe operation.

Compressor won't start or runs intermittently? This start relay and overload helps the motor get up to speed so your refrigerator runs reliably again.

Compressor won't start or runs hot? This overload protector stops your refrigerator compressor from overheating and prevents premature failure.

Fix a refrigerator that won't cool or run with this compressor overload protector. Prevents compressor damage from electrical overheating. Easy install.

Refrigerator won't start or compressor clicks but doesn't run? This start relay and overload protector helps the compressor motor start reliably.

Compressor won't start or cycles on and off? This overload protector prevents motor damage by cutting power during overheating. DIY-friendly fix.

Fix a refrigerator compressor that won't start or runs hot with this overload protector. Protects the compressor from electrical damage. DIY repair.

Refrigerator compressor buzzing but not starting? This start relay and overload protector fixes clicking sounds and warm temps. DIY-friendly repair.