Kenmore / Sears Touch Pad

Dispenser buttons not responding or touchpad cracked? This refrigerator control panel cover protects the touchpad module. Simple snap-on install.

This white cover module is the exterior trim piece that hides and protects the appliance's control/module area while keeping the appliance looking finished. It restores a clean appearance and shields internal components from dust and contact. What it does:

• Covers the control/module opening to provide a finished, OEM look
• Protects internal electronics and wiring from accidental contact and debris
• Prevents visible cracks, chips, or discoloration from affecting the appliance's appearance
• Common replacement when the original cover is cracked, broken, faded, or missing

• Disconnect power to the appliance before starting work to avoid shock or injury
• Typically secures with clips or screws; remove surrounding trim as needed for access
• Handle carefully to avoid cracking the replacement cover during installation
• If internal electronics or mounting hardware are damaged, replace or repair those items separately

Replace your refrigerator's control panel housing box if cracked, damaged, or missing. Encloses and protects internal control components. Direct fit.

This cover-module is the outer control console cover that shields and finishes the appliance's control area, keeping the control electronics and buttons protected while restoring a clean, factory look. What it does:

• Protects internal control board and switches from spills, grease, and everyday wear
• Provides a finished surface for control buttons and displays to mount to
• Helps keep buttons and knobs properly aligned for reliable operation
• Restores cosmetic appearance where the original cover is cracked, faded, or damaged

• One cover-module

• Disconnect power to the appliance before starting any repair
• Remove any necessary trim or fasteners to access the control console; handle plastic tabs carefully to avoid breakage
• Align cover tabs and fasteners, then reinstall screws snugly — do not overtighten
• Transfer any buttons, overlays, or clips from the old cover to the new cover as needed

This label-module cover protects the appliance control module label and wiring area from dirt, moisture and accidental contact to keep identification visible and help maintain safe operation. Simple replacement restores the original protective enclosure. What it does

• Covers and shields the control/module label and adjacent wiring from dirt and spills
• Helps prevent accidental contact with module components during routine use or service
• Keeps part numbers and safety markings visible for future service
• Useful when the original cover is cracked, warped or missing

• Disconnect power to the appliance before starting any work to prevent shock or damage.
• Remove fasteners or snaps holding the old cover; handle clips carefully to avoid breakage.
• Align and snap or secure the replacement cover into place; verify the label is visible and the cover is seated.