Kitchenaid Refrigerator Parts

Had to replace the auger. The auger on my ice maker was made of plastic and had broken pieces off it. The new one is made of metal and seems to work much better. Was a fairly simple repair. However pay close attention when disassembling, I recommend using your cell phone and snap a pic of the different stages as I became a little confused when putting it back together. Ordered the part and it was here the next day. I'm very happy to have my ice coming down the chute again. By the way, I'm a 70... Read more

Ordered the part from the schematic, 2 days later the part arrived and slide right in, 20 second repair. Read more

Replaced all 3 circuit boards and now waiting two weeks to see if the problem returns or not... Read more

Installed a AP6007346 motor Read more

Watched a few of your well put together videos and could not afford a new Refrigerator right now because it was a built in so decided with the frost on the bottom of the freezer grill and the Refrigerator warming up decided to replace the Heater Element and Thermostat Defrost which took some time but so far so good lets hope that is all that is needed saved over 10,000.00 dollars for a new 48" built in for now! Thank you for your rushed order and videos I think you are a life saver got the part... Read more

We replaced the water valves in the refrigerator and in the basement. We also put on a new water tube Read more

Replace Read more

I ordered a large sized bin and bin frame for the refrigerator. The hardest part of ordering the 2 parts was trying to figure out the right bin and frame to order. There weren't any specific dimensions listed for the parts, just a diagram with a grid. Thankfully, I guessed right. Hopefully, the dimensions will be added to the site, so future customers won't need to guess. Read more

• Ice maker won't dispense ice

Removed old cap replace with new 5 min. works like new received new part in 2 days Read more

I ordered a new shelf. Simply pulled the old one off and inserted the new one. Took literally 5 seconds! Read more

Bought a new shelf and the associated parts. Read more

Replaced hoses. They were not an exact replacement but they did end up working with the purchase of one additional fitting (5/16 x 1/4 coupler) Read more

Popped the bad light out and replaced it with a new one. Read more

Troubleshot the oven by checking the broiler which worked good (same fuel valve). After reading the some tips about troubleshooting the Glow Ignitor I could see the broiler ignitor got white hot and the oven ignitor only got bright orange (orange to red causes intermittent ignition or mini explosions). Watched the how to video and it was good information. You should be observant about which openings in the back of the oven as to where the two wires are coming out of. My oven is over 12 years... Read more