Maytag Dishwasher Parts

The grommet was old and very caked with old dishwasher scum. So water was leaking through where the soap door latch goes into the door. I replaced the rubber grommet (and the plastic latch that came with the kit, even though the old one was probably fine). Fit perfectly and looked just like the old one. Works like a champ, no leaking! Read more

I replaced it with the wheel I ordered from AppliancePartsPros.com Read more

This is a 12 year old Kenmore, but my experience applies to many dishwashers. The machine had run for almost a year without being cleaned. I found parts had failed from age and water passages were jammed with hard-water deposits and pieces of food, labels, etc. that had gotten past the filters. I cleaned out what I could and replaced parts that could not be cleaned or were damaged. Dishwasher now works better than it has for years. The work, including ordering parts, took about 4 hours, but... Read more

Ordered the replacement pump seal kit from AppliancePartsPros. I watched the online how-to video on their website. The impeller was slightly stuck on the motor shaft due to age but overall was amazed at how easy it was to repair. Thanks AplianePartsPros! Read more

Ordered set of new casters from Appliance Parts Pros, received them the next day, removed old casters, installed new ones and Voila! Back in business again! Clean dishes! Read more

Removed front kick plate, found overflow valve assembly leaking . When parts arrived removed and replaced overflow valve. Took about 10 minutes Read more

Found OEM parts drawings at AppliancePartsPros.com; figured out which two parts I needed to replace; ordered and received them in 8-days.New replacement parts were IDENTICAL to the broken originals, i.e., truly OEM replacements; watched the two remove/install videos for replacing these two parts... very helpful (there are always tricks/sequences involved). About 1-hour start to finish. Our 9-year old Maytag dishwasher looks and works like new again. Thank you APP.com! Read more

Read directions on how to change the power cord and watched video on your site on how to change the drain hose. Everything went perfectly. Read more

Took the 6 hex screws out and simply unplugged a couple of wires off the control panel. Called appliance parts pros and gave them the part number that was embossed on part. They had it in stock and shipped it. I received it within 3 days. Plug the wires back into the part and replaced the 6 screws. 10 minutes top to repair. Highly recommend you doing this. Would have cost hundreds more if a professional had done this. Thanks !! Read more

Thanks to you, all went well. No problems. Read more

Replaced the felt seal and door vent assembly by removing the inside panel of the door and cleaning off the old seal and replacing with the new one. The vent assembly simply snapped out and was easy to replace with the new one. No more leaks and Mother was happy. Removal of the screws required a torx screw driver and someone to hold the door open while the panel was replaced. Easy fix. Read more

Replaced the coupler gasket. No leaks now. Read more

Replaced control board with OEM part from ApplianceParts Pro - fit exactly and remedied the problems. Simple to replace - turn off power (circuit breaker), remove internal door panel, remove control board cover and unplug wires/LED leads (the LED lead connectors on the board have a square tension slip ring around them that hold the leads - just pull these up away from board and they will release the leads) and then remove the controller board housing. The controller board is held into the... Read more

Replaced left hand rack adjuster. Read more

I removed the basket, studied the old adjusters before removing them, and installed the new ones using some of the old parts(adjustment levers and the covers). adjusters work like a charm.. the only tool required was a screwdriver with removable torque bit. Read more