Maytag Dishwasher Parts

I didn't know what was wrong at first. All I knew was that it was not cleaning well at all (especially top rack) and leaving food particles on everything. I was washing on power scrub with high heat and still poor cleaning. I suspected a clog so I pulled the dishwasher and removed the plumbing to check it out. I kept pulling apart, not finding any hint of a clog, until I got to the "chopper". I didn't know what it was supposed to look like but I knew that was not it. I ordered the part (got it... Read more

My dishwasher quit cleaning dishes and lost all pressure. The food screen would keep clogging up and I would have to take it out and clean it by hand. After putting a new impeller in, the "gears" on the impeller connected with the screen blades, the old impeller the "gears" were stripped off. And the new impeller comes with new seals, after taking old one out I noticed it wasn't long before my old seals would have started leaking. Very simple repair if you watch the great video that... Read more

Removed and replaced diverter motor. Ops check good, no more leaking. I'm guessing the seal was the problem but diverter ruined (water residue) from leaking over the last 5 years??? This seal is only available if you buy the tub so followed another review - removed diverter then gently pried out the seal, cleaned and then lubed with silicone grease. Also turned the seal 180 degrees or the opposite way before reinstalling the diverter and then wrapping it all back under the counter. Read more

Removed bottom cover, located leak at float switch, removed and replaced float switch kit. The toughest part of the repair was removing the Float & Retainer Assembly (in the interior of the machine tank) which broke when I pushed it back and pulled it straight up as suggested in the service manual. The Float Switch Kit (attached to, and below the float, below and outside the tank) has a folding plastic cover which fastens with plastic clips. If you open the switch kit before removing the... Read more

DIY, changed motor and sump. Put a dab of valve lubricant on seal. Wet outer seal of sump to get it to seat in bottom of tub. Cleaned electrical connectors corroded by leak. Coated connectors with dielectric grease. Had to buy additional clamp. Two clamps came in the sump package but both fit the smaller hose only. Neither fit the large hose. I wish the correct clamps were included. Home improvement store clamp is a little too wide to fit between ridges in large hose. Read more

Ordered a new detergent dispenser that arrived within two days. Removed screws on the inside of door that removes the front door panel. The detergent dispenser is held on by a bracket with six screws. There is one plugin that needs to be disconnected. Everything is reinstalled as before. It work as before. Read more

Figured same part to be bad - had no power to display board - could not see Control board on web site so I called and customer service gave me the part number to enter into their site and confirm that was what I needed Great service - I have ordered several times in the past. Read more

Replaced control Read more

• Not cleaning dishes properly

Ordered parts from appliance pro and installed was a easy repair saved service call no tolls was neede Read more

Replaced a bunch of parts Read more

The initial problem was just a simple blockage on the filter screen...until I dropped a screw. So, I had to take the rest of the insides apart to retrieve it. The original impeller would not come off easily, so I tried to pry it off. Naturally, that caused the threaded portion to break. The new impeller went on much more easily than the old one came off, and the dishwasher is back in action. Simple repair; there's really not much to the inside of this thing. Read more

Ordered & installed Read more