Maytag Washer Parts

Replaced lid switch Read more

• Lid or door will not open
• Lid or door won't close
• Won't start

New inner drum and front and rear outer drum; although other parts worked, still replaced the bellow and clamp, new door latch, and cleaned the hoses. Washer works great. Just like brand new. Even though matching dryer works, I am going to clean it up and replace some parts on it also. Read more

Removed the leaking hoses and seal. Installed the new ones. They all fit perfectly. The disassembly/reassembly of the washer took the most time. Read more

Based on symptoms it looked like the timer was not working. I did a web search to confirm this and found your web site. Entering the model number of the washer (Whirlpool) I found the timer and related information. This confirmed my diagnosis. I also looked at the video on how to change the timer. This was invaluable! The video saved me hours and probably a washing machine. I ordered the timer, it arrived as promised, I installed it per directions and the machine works... the video makes... Read more

First off I have to say that Appliance Parts Pro's saved me from hiring a repair person, and quite possibly just getting rid of my washing machine. Their video's helped out SOOOOOOOO much and the advice one of their agents gave me over their online chat helped me trouble shoot something when I got stuck. On top of this they shipped my parts fast enough that less than 12 hrs later they arrived, which allowed me to get my machine up and running way faster than the other options I had available.... Read more

18 year old Maytag Atlantis top load washer had a load knocking and rattle sound with excessive vibration when the tub was spinning, but not when it was agitating. They was no water leaking. I took the front panel off and carefully listened while I ran a cycle and the loud sound sounded like it was coming from the drain pump. So I took off the drive belt and noticed that it was glazed and that there was belt material on the drain pump and tub transmission pulleys. I removed the drain pump and... Read more

Disassembled and confirmed the clutch was bad. Also noticed a slight leak from the transmission shaft seal. Ordered replacement clutch, seal and oil from appliancepartspros.com. The parts arrived very quickly and exactly as ordered. Their repair videos were very accurate and made the job easy. I accomplished a quality repair at a reasonable cost. My thanks to the folks at appliancepartspros.com for making it possible! Read more

• Lid or door will not open
• Lid or door won't close

Wrote down model and serial number. Went to The Google to find replacement part. Among other choices, A'pplaincePartsPros.com came up. Quickly found the part. More to the point (of appreciation) is that there was a video right there on the page about how to replace this part. I hadn't tought much about it, since the lid easily came off with the pin broken. Watched the video, which was well done, and followed those steps quickly and easily. All done. The postscript is that I found the part of... Read more

• Noisy

I just wanted to put my experience here for all to see. I have a Maytag Neptune, MAH5500BWW, one of the original ones. I bought it back in 2002 and it has done many many loads of wash faithfully. So when the bearings started to get loud I thought it best to replace them, the seal kit and the belt. I did my research as best I could and decided to order the OEM parts from an appliance supplier. If you are replacing the bearings, watch on line videos prior to performing the job. It will... Read more

I purchased part #85753076A, Whirlpool Fabric Softener Dispenser. Popped off the top from the agitator and popped on the fabric softener dispenser. It took me less than a minute and it works perfectly! No more missing the rinse cycle!!! Read more

• Will not drain

Checked the circuit board to see if R11 was burnt and it was. They told me if the wax motor had a brown tip that I would have to replace the Machine control circuit board as well as the Wax motor. I ordered the new parts put them in and it worked. Read more

My Mom's Kenmore had a burnt plastic smell after a thunderstorm. Found motor capacitor had melted through, dumping liquid platic "spaghetti" onto the insulation blanket under the washer. All other compents looked fine. Told her not to use it until I replaced capacitor. The washer is 4 yrs old but the new capacitor revision was 3 letters higher, so they've made some design changes. Externally it looks the same. There is a large number on the capacitor, but the part is ordered by the much... Read more

I removed the old one, broken bits and all. I replaced it with the new one. Read more

New lid Read more

Replaced tray, The only difficulty was connecting the drain hose to the bottom of the tray. Difficult to get hand on the hose. Read more

I diagnosed the problem, identified faulty parts, and replaced those components. Read more