Range Control Board

Replaced with this igniter. Read more

After researching on line what the error code meant I ordered a new electronic control board and oven sensor. It is important to make sure you have all the details of your model number when looking for a part. The oven technician looked at our oven said the replacement parts were no longer being made. I went on line and got the same answer until I saw my model number and a 13 after it. I clicked on the link and the control panel was exactly the same as mine. With a flashlight I was able to look... Read more

Not having any local Thermador support I took the advise from KC on the repair forum. The repair consisted of removing and replacing the control and relay board. The hardest part of the job was working behind the stove while it was pulled from the wall. ( didn't want to scratch my floor ). Over all the repair was simple just pulling wires from old board and installing on new board. The directions sent with the parts are excellent and easy for anyone to follow. I am glad I found this site... I... Read more

1. I ordered a new burner. It didn't fix it. 2. I ordered a new burner switch. It didn't fix it. But still needed to be replaced because I cold see itt had burned out. 3. I checked the wires to the burner, then to the switch, they were all fine. I probably should have done this first. My last possible solution was the simmer switch board. I couldn't visually see any points of failure but it really was my last resort before calling a repair man or buying a new stove. 4. I ordered new... Read more

I started searching for the model number online and GE did not have any info but I found appliancepartspro.com, they had the control board which I was looking for, so I called them before I bought it, they confirmed the part and put the order in. I had the part the next day and installed that night, it worked perfect and is continuing to work. With the warrantee of 365 day I can't go wrong. Thanks Read more

The part I ordered was easy to replace and it fixed the problem! Read more

I replaced the digital oven controller. Read more

Replaced Control box, Very easy to install. Remember to DISCONNECT power cord. Read more

Replaced control panel and overlay it was very easy. Just four screws and a few connectors.. If you plan on replacing the control board be sure to order a new overlay also. It makes the repair so much easier. Read more

I needed to replace the light bulb in the oven, but forgot to turn off the breaker and unplug the oven (NEVER DO THIS)!!! There was a spark, and my control board was fried. The range top worked fine, so I knew if was the control board (if you no longer see the digital clock and none of the buttons are responsive, it's a pretty good indicator that it's toast). Simple fix. Buy this part, turn off the breaker, unplug the appliance, remove the backing from the unit, remove 4 screws, swap out the... Read more

Looked it up on you tube found two possible problems, eliminated oven sensor, left only mother board, replaced, very simple procedure, all working well now. Read more