Range / Cooktop / Oven Control Board

Fix an oven that won't heat, displays error codes, or has a non-responsive touchpad with this electronic control board. Moderate repair difficulty.

Fix an oven that won't maintain accurate temperature or runs too hot. This electronic control board regulates heating cycles. Moderate difficulty repair.

This filter board is the electronic control board that monitors and communicates your refrigerator's filter status and related dispenser signals, restoring proper filter detection and indicator operation. What it does

• Monitors filter presence and communicates filter status to the display or dispenser
• Sends/receives signals that enable filter-related indicator lights and alerts
• Helps restore dispenser/filter indicator functionality when the original board fails
• Common symptom: filter status light stays on or does not change after replacing the filter
• Common symptom: dispenser or filter indicator behaves intermittently or not at all

• Disconnect power to the appliance before starting service to avoid shock
• Handle the board by the edges and avoid touching contacts; protect against static discharge
• Access typically requires removing the dispenser/display or control housing—retain screws and mounting hardware

Generator control board for cooktop center module. Replaces cracked, damaged, or malfunctioning circuit board. Mounts inside cooktop control assembly.

Replace your cooktop's control board if the existing board is damaged, burned out, or malfunctioning. This circuit board installs inside the control panel.

Housing assembly for cooktop induction control board. Protects internal electronics and wiring. Replace if cracked, damaged, or missing components.

Fix an oven that won't heat, shuts down during cooking, or has a blank display. This control board manages temperature regulation and oven functions.

Distributes power to control and heating circuits. Replace when board is damaged, failed, or non-responsive. Installs at bottom of cooktop unit.

Fix F7 E6 errors, dead displays, or temperature issues. This electronic control board restores oven heating and panel functions. Moderate DIY install.

This electronic control board with overlay manages your range or wall oven's heating and user interface. Replacing a failing control restores accurate temperature regulation, proper bake/broil operation, and a readable display so the appliance responds as it should.

• Regulates oven heat by switching bake/broil circuits based on temperature sensor feedback
• Powers and displays the clock, timer, and status messages
• Interprets keypad/touchpad inputs to run bake, broil, and clean cycles
• Common failure symptoms: dark or flickering display, unresponsive buttons, oven won't start or maintain set temperature, or error codes

• Disconnect power at the breaker before servicing; verify no voltage present
• Use ESD precautions and handle the board by its edges
• Photograph/label wiring; move connectors one at a time to the new board and seat fully
• After installation, run any model-specific checks or calibrations per the service/tech sheet

Fix an oven that won't heat or has no display with this electronic control board. Restores bake and broil functions. Moderately difficult replacement.

Fix error codes, blank displays, or ovens that won't heat with this wall oven control board. Controls temperature and timing functions. Moderate repair.

Fix unresponsive buttons, blank display, or oven functions not working. This clock and control board assembly restores time display and bake controls.

Fix an oven that shuts off randomly, won't start, or shows error codes. This electronic control board manages heating cycles and user inputs.