Range / Cooktop / Oven Motor

Tangential blower that moves air through the oven's ventilation and control areas to help keep components cool and vent heat. Replacing a failed blower restores airflow for quieter operation and more consistent cooling around electronics. What it does:

• Circulates air across the oven vent and control area to dissipate heat; symptoms of failure include little or no airflow.
• Helps cool control electronics and nearby components; failure can cause high temperatures or thermal-related shutdowns.
• Reduces noisy or rough fan operation when bearings or motor wear.
• Supports proper venting after use to help the appliance cool down safely.

• Disconnect power to the appliance before accessing or replacing the blower.
• Allow the appliance to cool fully; remove access panels to reach the blower.
• Handle the blower and connector gently to avoid damaging the motor shaft or wiring; ensure correct orientation when reinstalling.

This small drive motor rotates the turntable plate inside the microwave to ensure even heating of food. It connects to the turntable coupler beneath the glass tray and spins at a slow, steady speed. Replace this motor if the turntable stops rotating, turns intermittently, or makes grinding noises during operation.

This blower assembly circulates air through the appliance to support drying and venting, restoring proper airflow for consistent performance. It replaces a worn or damaged fan wheel and housing to reduce overheating and poor drying. What it does:

• Moves air through the appliance to aid drying and ventilation
• Restores airflow lost from cracked, warped, or broken blower wheel
• Helps eliminate overheating, long-dry times, or reduced airflow
• Works with the motor and ducting to maintain proper exhaust flow

• One blower assembly

• Disconnect power before servicing to avoid shock or injury
• Inspect motor shaft and mounting before installing; replace any damaged hardware
• Ensure blower is oriented and secured per manufacturer alignment to prevent noise or imbalance
• Verify clear, unrestricted ducting after installation for proper performance

This cooling fan is located inside the range and circulates air to prevent overheating of internal components. Replace when you hear unusual noises, the oven overheats, or the fan doesn't operate during cooking.

Oven overheating or running loud? This cooling fan motor assembly circulates air to prevent overheating and reduce noise. Direct-fit replacement part.

Replace a failed transformer cooling fan motor causing overheating issues. Circulates air to keep electrical components cool and maintain reliable operation.

Range oven not heating evenly or convection fan stopped working? This blower motor circulates air in the oven cavity for even cooking and baking results.

Replace a noisy or failed cooktop ventilation fan with this blower motor. Restores proper air circulation. Moderate DIY repair for electric cooktops.

This is a cooling fan assembly used in wall ovens and ranges to circulate air and prevent overheating of internal components and surrounding cabinetry. It helps dissipate heat from the oven cavity and electronics during and after cooking cycles. Replace this fan if you notice excessive heat on the outer surfaces of the oven, the fan runs noisily or intermittently, or the oven displays overheating error codes.

Fix squealing noises or convection that shuts down after preheating. This oven fan motor circulates air for even baking and roasting. Common DIY repair.

This motor and switch assembly controls the automatic locking mechanism on the oven door, primarily used during the self-clean cycle. It engages and disengages the door latch to secure the door shut at high temperatures. Replace this part if the oven door fails to lock or unlock during self-cleaning, if the self-clean cycle won't start, or if you receive a door lock error code.

Fix uneven oven temperatures or overheating electronics with this 45mm tangential blower motor. Restores directed airflow in your gas range cavity.

This Is A Blower Motor !!!! For Turntable Motor Use W10642989!!!!

Note: No longer comes with fan blade.