Range Hood Parts

This hood damper replaces the vent flap that opens to let exhaust air escape and closes to block outside air and backdrafts when the hood is off. It restores proper airflow control for range/hood ventilation. What it does:

• Opens with fan operation to allow cooking exhaust to vent outside
• Closes when the hood is off to reduce drafts and prevent outside air entry
• Stops wind or odors from coming back into the kitchen when working correctly
• Common symptom: fan runs but little or no exhaust, or persistent backdraft/odors

• Disconnect power to the hood or range hood assembly before beginning work
• Access typically requires removing the hood/vent housing or grille to reach the damper
• Inspect surrounding duct and mounting for damage; replace damper if warped or stuck

This grease channel is the molded drip tray that collects and routes cooking grease away from the vent/hood area to help keep the appliance interior cleaner and reduce smoke buildup. Durable replacement for worn or cracked channels. What it does:

• Captures and channels drips and grease from the cooking surface or vent inlet
• Prevents grease from pooling inside the vent or cabinet area
• Helps reduce smoke, odors and potential staining from accumulated grease
• Restores proper drainage when the original channel is cracked, warped or missing

• One grease channel/drip tray as pictured

• Follow the appliance service manual for access and removal steps; appliance disassembly may be required
• Use appropriate hand tools; avoid sharp edges on metal housings and wear gloves
• Disconnect power (and gas if applicable) before servicing to avoid injury
• Only reinstall if the channel seats properly and does not interfere with other parts

This pushbutton switch replaces a worn or broken control button so your appliance's front-panel function responds reliably. It restores tactile push-button control for start, cycle selection or other front-panel operations. What it does:

• Sends the electrical signal when a front-panel button is pressed so the selected function starts
• Restores responsive push action when the original button is stuck, loose, or unresponsive
• Helps fix intermittent or no-response symptoms from a damaged or corroded control button
• Fits into the control panel and connects to existing wiring or harness terminals

• Disconnect power before beginning any repair
• Access the control panel per your model's service instructions; this part typically secures with snap clips or a retaining screw
• Transfer any button cap, bezel, or wiring harness carefully; confirm terminal alignment before reassembly
• Test the control function with power restored before fully reassembling the panel

This moulding is a replacement cabinet trim piece that restores a clean, finished appearance and helps cover gaps along the appliance opening. It matches the original fit and trim profile for a seamless look. What it does:

• Covers and protects exposed edges and seams on the appliance cabinet or door area
• Restores factory appearance where trim is cracked, dented, or missing
• Helps reduce dirt and debris accumulation in the gap it covers
• Secures against small drafts or light snagging where trim has come loose

• Disconnect power to the appliance or unplug before starting work
• Remove any adjacent trim or fasteners carefully to access the moulding
• Align the moulding with the cabinet/door edge and press or fasten into place per original mounting points