Refrigerator Gasket & Seal

I ordered the replacement part, took the old seal out, and popped the new one in. It was a straightforward process. The seal came in one piece and I had to make sure the corners were firmly in before smoothing out the sides of the seal. Read more

Remove old gasket clean the area and put new gasket on Read more

Based on my model # and serial # the Appliance Parts Pros were able to quickly find and ship the gaskets I needed. The instructional videos showed me how to remove the old and replace with the new. I was able to easily do it myself. Read more

Removed old seal and replaced with with new seal. It took approximately 5 minutes, the new seal just snaps in on this model of refrigerator. Also, the new seal came nicely boxed to prevent wrinkles. Read more

Put a new one on. Read more

Replaced it. Read more

Ordered the part via the model number. Removed the old gasket (just pulls out of the indentations and cleaned the channel for the gasket. Pushed into the channel and no more frost forming in the freezer. Read more

The freezer door on my 12-yr old GE side-by-side refrigerator/freezer would not stay completely shut resulting in temperature variations and ice buildup from outside humidity seeping into the freezer compartment. These problems were exacerbated by the fact that this appliance is located in my garage in the heat / humidity of the Atlanta, GA area. I applied a thin layer of petroleum jelly to the gasket which improved the seal but did not completely solve the problem. I discovered that... Read more

Replaced both the door gasket * defrost timer and everything works great. Read more

I searched online for replacement parts and Appliance Parts Pros had the part in stock. Before I ordered the part, I watched the video to see if I could handle the repair. I ordered the part and soaked the gaskets with warm water in the tub. The old gaskets had a much simpler setup, so no cutting was involved. I simply pulled the old gasket out of the track without issues, and installed the new one with finger pressure. Per the video, I took both doors off. However, due to the design, I could... Read more

Ordered replacement part from Appliance Parts Pros Read more

Left new gasket on the table overnight so it could stretch out. Removed the door. Temporarily replaced it with plastic and tape. Pulled off old gasket. Cleaned surfaces with decreaser and wiped dry with paper towels and alcohol. Inserted new gasket. Replaced door. Read more

The fix went great. I replaced the right-side door switch and it works great. The switch came as a three prong, and the original was a two prong. I matched the two prong wires with/on where they go on the switch, and it worked great. Next is the left door gasket. I am letting the new door gasket lay flat for a few days to see if the folded kinks/creases will relax out. They do instruct to use very hot water to get the folded shipping kinks out of it and will try that as a last resort. Read more

Removed and replaced the gasket. Read more

Followed directions. Read more

I ordered the part from Appliancepartspros.com. It arrived in two days and was super easy to install. Read more