Need Help?
Call
Fix dishes not drying or cycles taking 3+ hours. This heating element heats wash water and enables drying. Moderate DIY repair with video guide.
Ordered new heater/thermostat piece. Read more
Usually ships within 4 - 14 days
This kit includes a simmer control board that regulates low-heat burner operation on the cooktop, allowing precise temperature control at simmer settings. The board manages the cycling of the burner element to maintain consistent low temperatures. Replace this kit if your burners won't maintain a simmer, cycle erratically at low settings, or if the existing control board shows signs of damage or failure.
I ordered all the parts from AppliancePartsPros.com and in two days I had every new part that was. Ordered. After being told from the appliance repair company that I wouldn’t get parts for months. I received all parts within 4 days, 19 different parts! Read more
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals. Read more
Detergent door won't close or stay shut? Replace the dispenser assembly. Takes about 20 minutes with basic tools—remove inner door panel and swap out.
Removed back of dishwasher with hex screw driver 5 min Unplugged power cord 30 secs Loosened metal bracket on top and bottom with screwdriver 5 min Pushed dispenser in and removed from dishwasher 5 min Positioned new unit in space and snapped into place 1 min Plugged electrics back in 1 min Screwed back on 3 min Roughly 20 min. I am nontechnical and rarely do repairs. Read more
Keep your appliance's controls working reliably with this switch cover. It mounts over a switch to hold it in place and shield it from damage, helping ensure consistent actuation and long service life.
I took apart the hood cover and noticed that the cover switch had broken away from the screw. I researched the part on this website and identified the correct part, ordered it, and replaced the part. It was challenging as the angles were awkward when I was working under the hood, but I took my time and only needed a screw driver. I'm sure I saved hundreds of dollars doing this repair myself rather than calling in a professional. Read more
Protective cap that mounts over control switches on your range hood control panel. Replace if cracked, broken, or missing to keep switches properly aligned.
This upper trim strip finishes the top edge of the appliance's front opening, restoring a clean look and helping protect nearby components. Replace a cracked, missing, or loose strip to keep panels aligned and secure.
Appliance Parts Pro online , on line help gave me exact measurements to insure I was ordering correct piece as a women not used to order appliance parts this really helped ...thanks Parts Pro Read more
This is a genuine OEM replacement o-ring sourced directly from the manufacturer for use on range vent hood switches. The o-ring provides a tight seal for the switch and keeps smoke from escaping through the switch connection. If the o-ring becomes worn or damaged, the vent will not remove smoke during cooking and should be replaced. Heat and debris pulled through the vent may cause the o-ring to warp. O-rings are not designed to last forever and may need to be replaced during the life of the appliance to keep it functioning correctly.To start, disconnect the power to the vent hood and dismantle the vent in order to reach the switch. To start, disconnect the switch and locate the o-ring. Remove the old one and dispose of it. Place the new o-ring in the groove and press firmly to seal the part. Lubrication is not necessary for installing the new o-ring. Reassemble the switch and put the vent hood back in place. Connect the power and try the switch to make sure it works. This o-ring is made of heavy-duty black rubber is and sold individually. It is designed for use in range hoods manufactured by Thermidor.
Found replacing the switch to be doable, but it was quite a delicate operation. This was for a Thermador range with a broken downdraft switch. It required the removal of 5 small screws which could easily be fumbled and dropped down where it would be difficult, if not impossible to retrieve. Two of the screws were facing the back, so it was a blind operation to remove and replace the screws. Required an offset screwdriver, as space was tight. So, be EXTREMELY careful to not drop the screws and... Read more
Fix a dishwasher door that won't close or latch properly. This latch and strike plate assembly restores secure door closure and safe operation.
Replaced check valve, was broken off and plugged the drain Read more
Rear pump housing for the washer drain/pump assembly. Replaces the worn rear housing that supports the impeller and bearing, helping restore proper draining and reduce leaks or unusual pump noises when the housing fails. What it does:
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger. When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed... Read more
Oven won't heat or shuts off during use? This thermal fuse cuts power when temperature exceeds safe limits. Moderate DIY repair with multimeter testing.
Oven not heating evenly in convection mode? This rear convection heating element restores proper temperature. DIY-friendly, typically installs in 10-20 minutes.
Checked the two elements that I could see ,then removed back cover and you could see element around fan had blew apart a.Got help from one of your techs in finding right part ,received part the second day after placing order.replacing took less than 20 minutes.thanks for your help. Read more
Captures grease and cooking vapors to keep air fresh and prevent buildup. Replace when clogged or discolored. Verify fit by model number and dimensions.
I ordered replacement filters--the filters fit inside the vent. I did not have a part number, just the model and the size. These fit great! My down draft was installed in 1996, so I was afraid the part might not be available. Success! Read more
Ice dispenser not working or making grinding noises? A worn ice auger often causes jams and prevents cubes from dispensing. DIY fix in about 20 minutes.
Easy and quick fix. Replaced the shaft, auger and coupling in about 20 min. Just make sure you take a picture of how the blades go together AND pay attention to the A-B-C on the ice chipper blades. Read more
Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.
The oven door must be completely removed from the base oven before the repair can be done. The only caveat in to mark the inner dual pane assembly left and right before disassembly as this part is symmetrical and can be reversed on reassembly. This may lead to screw hole misalignment issues when larger door parts are reattached leading to confusion and frustration. Minor Dremel burring of the glass corners (one mm) was necessary for proper fit. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.