Wall Oven Parts

I purchased a new elelmnt and fixed it myself!! Read more

Looked at YouTube, took it off and figured out which one it was and ordered one from AppliancePartsPros.com. It was very easy. Just tucked the ends in with a screwdriver. Delivery from Appliance Parts was easy and fast. Read more

With the help of Wendee and Karen, we finally figured out my model numbers and which parts where correct. I ordered the parts and all arrived the next day except for the Broiler element which arrived in 2 days. I installed the new Baking Element myself. Took longer to figure out which curcuit braker to turn off. In about 30 minutes I had a brand new Baking Element in my oven working perfectly. On the following day, I installed the Broiler Element. That took a bit longer as it sits in a metal... Read more

• Little to no heat when baking

Repair video was very helpful. Followed the instructions and the element was replaced easily and correctly. Read more

First, I took an ohm reading across the elements and determined the bad one, which was failed, open circuit. (Zero continuity) I then replaced the lower heating element of the upper oven. Although the design of the oven and element make it appear that it will just drop down and slide out the front, this is not quite the case. There is not enough clearance for it to drop all the way down. You have to pull the entire double-oven unit out of the wall, separate the upper and lower halves a few... Read more

Ordered replacement parts Read more

Removed the top and replaced 2 of the electrodes. Read more

Ordered replacement parts Read more

I removed end caps installed one end cap fitted handle to this end cap then fitted 2nd end cap to handle then attached this end cap to stove door. Read more

Ordered replacement drip pans Read more

REPLACE door hinges and door handle (about 30 minutes) 1. Open the door to the first catch. 2. Lift the latch keepers (stoppers) on the hinge. 3. Lift / pull the door away from the oven. 4. set on a flat surface with inside of door up. 5. Remove three screws on the bottom of the door. 6. Remove two screws on the inside towards of the top of the door (gold in color). These are long wood type screws. 7. carefully lift the inner door from the outer door. (NOTE: there are two metal pieces that the... Read more

I BOUGHT NEW BURNERS FRM YOU. EXCELLENT PRICE, SHIPPING ARRIVAL, PARTS WERE ORIGINAL GE PARTS. TY Read more

• Little to no heat when broiling
• Little to no heat when baking
• Gas igniter glows, but will not light
• Won't start

Replaced the igniter, Simple but there are several points to remember. TURN THE POWER OFF 1) remove the oven door or you will have a hard time reaching the back of the oven. Mine just lifted off. 2) The igniter tip is fragile put a drop cloth over the oven floor in case you drop it even after it is in its holder. 3) The drop cloth will catch screws too if you drop them so they won't fall into the oven. 4) The cable from the oven is very short even after pulling it out from the hole at the back.... Read more

• Touchpad does not respond

$4 part and a little time saved $250 if I had had to replace the whole plug-in duel burner unit for our Jenn-Air range. Spade that was replaced fed both burners, other two spades just one. If your burners do not turn on, check the spades before you replace the coils. Read more

We ordered the parts we needed, and received it with-in a week. My husband was able to covert the stove in one evening. Read more