Washer Divider Or Deflector

This diverter valve directs wash water inside the machine, switching flow between internal paths during wash and drain/recirculation steps. Replacing a failed diverter restores proper water routing so cycles advance and complete as designed.

• Redirects water between the drain and recirculation/spray paths as commanded by the control
• Ensures correct water flow for wash, rinse, and drain steps
• A sticking or failed diverter can cause slow/no drain or no recirculation/spray
• May lead to cycle pauses/errors, unusual clicking/buzzing from the valve area, or leaks at the valve body/ports

• Unplug the washer and turn off water supply; expect residual water in hoses
• Access location varies by model; typically mounted along the pump/hoses under the cabinet
• Move hoses/clamps and the electrical connector one at a time; match port orientation
• After installation, run a rinse/drain test and check all connections for leaks

This replacement funnel guides dryer airflow from the drum into the lint screen housing. Replacing a cracked or missing funnel helps restore a tight air path for efficient drying and keeps lint contained inside the proper ductwork.

• Directs exhaust air from the drum into the lint screen/duct path
• Helps prevent lint blowback and cabinet contamination
• A damaged or warped funnel can cause longer dry times and poor airflow
• Contribute to excess lint in the drum or overheating symptoms

• Disconnect power; for gas models, also shut off the gas supply
• Access is typically through the top or front panel; remove lint duct fasteners as needed
• Transfer and reuse existing mounting hardware and any seals
• Clean lint from mating ducts and ensure an airtight fit before reassembly

This funnel shower head directs water flow inside the dispenser, helping water reach the glass or icemaker chute reliably. It replaces a worn or cracked funnel to restore proper water direction and reduce splashing. What it does:

• Channels dispenser water so it flows where expected and limits splatter
• Replaces cracked, warped, or clogged funnel pieces that divert flow
• Restores secure fit inside the dispenser area for consistent performance
• Reduces leaks and dripping caused by damaged funnels

• Disconnect power and shut off water to the appliance before starting
• Remove the old funnel carefully to avoid damaging surrounding trim
• Press or snap the new funnel into place until fully seated; do not force
• Check connections and test dispenser for leaks after reassembly

This coin chute is the front-facing coin entry assembly that guides coins into the coinbox for coin-operated laundry machines. It restores proper coin acceptance and routing so users can reliably insert payment. What it does:

• Guides inserted coins into the coinbox and helps prevent coins from falling out of alignment
• Replaces a worn, cracked, or jammed coin entry that can cause coins to stick or be rejected
• Helps restore normal coin-operated function so customers can pay and start cycles
• Fits the machine's front panel and works with the existing coinbox and lock assembly

• One coin chute

• Disconnect power to the machine before servicing to avoid electrical hazard
• Remove the front panel or coinbox access per manufacturer instructions to reach the chute
• Secure with the factory screws/clips; verify coins pass through freely before reassembly
• If the coinbox or lock is damaged or missing, inspect those parts separately.