Whirlpool Cap Or Cover

Replacement hinge cover cap for refrigerator door. Restores finished appearance after door reversal or replaces cracked, broken, or missing covers.

Replace your refrigerator's damaged or missing cover cap. This protective cover installs over internal components to restore a finished appearance.

Plastic cover cap for refrigerator installation. Replaces cracked, broken, or missing covers. Snaps into place to provide finished appearance.

Protective cover for refrigerator control console. Shields control panel from moisture, dust, and damage. Replace if cracked, broken, or missing.

Color: Apollo Gray

Protective cover for the high voltage control unit in your refrigerator. Replace if cracked, broken, or missing to protect electrical components.

Grey right-hand hinge cover cap for bottom-mount refrigerators. Replace your cracked, broken, or missing hinge cover to restore a clean appearance.

Replacement access panel cover for side-by-side refrigerators. Encloses internal wiring and components. Needed when original is cracked or missing.

This plastic filter cover protects the dishwasher's filter and sump, helping keep food and debris out of the pump while directing wash water through the filter area for proper draining and cleaning performance. What it does:

• Covers and secures the filter/sump area so debris is trapped before reaching the pump
• Helps channel wash water through the filter for effective filtering and draining
• Reduces risk of pump clogs and noisy operation from loose debris
• Commonly replaced when cracked, warped, or not seating properly which can cause poor draining or food re-deposit

• Disconnect power to the appliance before performing any service
• Remove the lower rack and lift out the filter assembly to access the cover
• Inspect and clean the filter and sump area before installing the new cover
• Refer to the appliance's diagram for correct orientation and fastening

Protective cover for water valves and inlet hoses. Replace if cracked, broken, or missing to shield components from debris and accidental contact.

Secures and seals the water filter in its housing. Replace if cracked, broken, or missing to restore a proper fit after filter changes.

Printed front cover that restores button labels on your washer dryer combo console. Replace when overlay is cracked, faded, peeling, or worn for clear controls.

Protective cap for blenders that covers exposed shafts and openings. Replace if cracked, broken, or missing to prevent dirt and debris buildup.