Whirlpool Cap Or Cover

Color: Apollo Gray

Color: Grey / Right Hand

This plastic filter cover protects the dishwasher's filter and sump, helping keep food and debris out of the pump while directing wash water through the filter area for proper draining and cleaning performance. What it does:

• Covers and secures the filter/sump area so debris is trapped before reaching the pump
• Helps channel wash water through the filter for effective filtering and draining
• Reduces risk of pump clogs and noisy operation from loose debris
• Commonly replaced when cracked, warped, or not seating properly which can cause poor draining or food re-deposit

• Disconnect power to the appliance before performing any service
• Remove the lower rack and lift out the filter assembly to access the cover
• Inspect and clean the filter and sump area before installing the new cover
• Refer to the appliance's diagram for correct orientation and fastening

This replacement cover protects water-related components on select Whirlpool washers, helping keep valves and hoses shielded from debris and incidental contact for reliable water flow management. What it does

• Protects water valves, inlet hoses, and nearby fittings from dirt and accidental contact
• Helps maintain proper water routing by keeping components covered and positioned
• Commonly replaced if cracked, broken, warped, or missing after impact or wear
• Can prevent debris buildup that interferes with valve operation or connections

• One replacement cover as pictured

• Disconnect power and shut off the water supply before starting any repair
• Secure with existing screws or clips
• Do not force the cover into place; inspect surrounding fittings and hoses for damage while installing
• If you see leaks after installation, recheck hose connections and valve seating; replace defective parts as needed

This water filter cover secures and seals the refrigerator's replaceable water filter, helping maintain correct water flow and prevent leaks. It restores a snug fit after filter changes for reliable dispensing. What it does:

• Secures the replaceable water filter in its housing and holds it in place
• Seals the filter area to help prevent water leaks around the filter
• Directs water through the filter for proper flow and filtration
• Can resolve symptoms like a loose or unseated filter, leaks near the filter housing, or difficulty installing the filter

• Turn off the refrigerator water supply and dispense remaining water before starting
• Remove the existing filter per manufacturer instructions, then position and snap or twist the cover into place
• Inspect filter O-rings and housing for damage; replace damaged seals before reinstalling

This replacement cover restores the appliance's finished appearance while protecting internal components from dust and debris. It provides a clean, secure barrier so panels stay in place and the appliance looks and functions as intended. What it does:

• Protects internal parts and wiring from exposure to dust, moisture, and accidental contact
• Helps keep panels securely in place to prevent rattling or loose trim
• Restores the appliance's exterior appearance after damage or loss
• Commonly replaced when the original cover is cracked, broken, bent, or missing

• One replacement cover

• Disconnect power (and water, if applicable) before starting any repair
• Use basic hand tools; support panels to avoid dropping or scratching surfaces
• Handle edges carefully; some covers or mounting points may be sharp
• Refer to your appliance's service manual or parts diagram for exact placement and fastener locations

This control panel overlay is the printed front cover that restores button labels and the finished appearance of the appliance console. It helps make controls readable and gives the console a like-new look. What it does:

• Covers the appliance console with printed button labels and icons for user controls
• Replaces faded, scratched, or peeling front graphics that make buttons hard to read
• Restores a clean, visually accurate control surface for normal operation
• Helps protect the underlying control components from light wear and cosmetic damage

• One control panel overlay

• Disconnect power at the breaker or unplug the appliance before starting any work
• Remove the console or access panel to avoid damaging snaps or clips
• Peel off the old overlay and clean the surface fully before aligning and securing the new overlay
• If adhesive backing or clips are involved, verify correct alignment before final adhesion