Whirlpool Parts

This refrigerator water filter housing holds the filter and routes water through it to the dispenser and ice maker. Replace it if the housing is cracked, leaking, or won't engage the filter to help restore consistent water flow. What it does:

• Directs household water through the installed filter to the dispenser and ice maker
• Locks and seals the filter; opens/closes the internal shutoff when the filter is engaged
• Helps maintain proper flow and reduce leaks at the filter connection
• Common failure symptoms may include water dripping from the filter area, the filter not seating or popping out, low/no dispenser flow, or no ice production

• 1 water filter housing assembly

• Unplug the refrigerator and shut off the water supply; dispense water to relieve pressure
• Place a towel under the area to catch residual water
• Remove any cover/bracket as needed; disconnect tubing from quick-connect fittings and note routing/orientation
• Install the new housing, fully seat tubing in the fittings, restore water and power, check for leaks, and flush per your model's instructions

The Charcoal Filter is an OEM part for Whirlpool microwaves. This filter is designed to remove cooking odors and smoke from the air circulated through the microwave's venting system. It is especially important in over-the-range microwaves that recirculate air rather than venting it outside. The filter measures about 12 inches wide by 6 inches deep. This is a 2 Pack.

Causes of a bad charcoal filter can include saturation from grease and odors over time, blockage from accumulated debris, or deterioration of the filter material. Regular replacement is necessary to maintain effective air filtration and proper microwave performance.

Symptoms of a bad Charcoal Filter include:

• Persistent cooking odors lingering in the kitchen
• Reduced ventilation efficiency
• Smoke not being properly filtered during cooking
• Noticeable decrease in the microwave's air circulation

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This refrigerator water filter housing assembly secures and seals the filter while routing water to the dispenser and ice maker. Replacing a cracked or worn housing helps stop leaks and restores consistent water flow through the system.

• Holds the water filter and maintains watertight seals at the connections
• Directs water through the filter to the dispenser and ice maker
• Addresses leaks around the filter area
• Improves weak or no dispenser/ice maker water flow when the housing is damaged

• Disconnect power and shut off the household water supply before servicing
• Dispense water to relieve pressure; place a towel to catch residual water
• Note tubing orientation, release the fittings, and swap the housing
• Restore water and power, check for leaks, and run water to purge air from the system

The Water Filter Housing is an OEM part for Whirlpool refrigerators. It houses the water filter which helps improve taste and protects connected water lines and ice maker components.

Causes can include cracks or damage from falls/impacts, deterioration of seals and gaskets over time, or blockages in the internal filter cavity.

Symptoms of a bad filter housing include:

• Leaks or water spills around the filter area
• Inability to easily change out the water filter cartridge
• Cracks or issues with the housing door/latch mechanism
• Mineral or sediment buildup that impacts filter performance

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The water filter housing holds the refrigerator's filter cartridge and seals the water lines, directing water through the filter to the dispenser and ice maker. Replace a cracked or leaking housing to restore proper flow and prevent leaks. What it does:

• Secures the water filter and maintains watertight seals at the connections
• Routes water through the filter before it reaches the dispenser and ice maker
• Provides the connection point for easy filter installation and removal
• Typical symptoms: leaks around the filter area, low/no water flow, or a filter that won't seat or eject properly

• Disconnect power and shut off the household water supply
• Dispense water to relieve pressure; place a towel to catch residual water
• Note tube routing; release tubing from quick-connect fittings and remove mounting screws to swap the housing; transfer any brackets or screws as needed
• Restore water and power, then check all connections for leaks and flush to clear air from the lines

Color: metallic. Measures about 12 inches wide by 6 inches deep.

The Charcoal Filter is an OEM part for Whirlpool microwaves. It is designed to remove odors and impurities from the air that circulates through the microwave during cooking.  The filter measures about 7 inches wide by 6-1/2 inches deep.

Causes of a bad charcoal filter can include prolonged use without replacement, accumulation of grease and food particles, or damage due to cleaning with harsh chemicals or abrasives.

Symptoms of a bad charcoal filter include:

• Reduced effectiveness in odor removal
• Excessive smoke or steam during cooking
• Unusual or unpleasant smells persisting in the kitchen
• Discoloration or visible debris on the filter

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This refrigerator water filter housing holds the filter cartridge and routes water through the dispenser and ice system. Replacing a cracked or leaking housing restores proper sealing, water flow, and smooth, reliable filter changes.

• Secures the water filter and seals the inlet/outlet connections
• Channels water through the filter to the dispenser and ice maker
• Helps correct leaks around the filter area
• Common symptoms: low/no dispenser flow, ice maker not filling, filter won't seat or release

• Disconnect power and turn off the household water supply before servicing
• Dispense water to relieve line pressure; place a towel to catch residual water
• Access location varies by model; remove the grille or interior cover, then disconnect the water lines and mounting hardware from the old housing
• Install the new housing, ensure tubing is fully seated, restore water and power, check for leaks, and purge air by dispensing water

Color: metallic. Measures about 12 inches wide by 6 inches deep.

Keep your vent hood performing at its best. This 3-pack of recirculation filters refreshes the air in non-ducted installations by capturing fine cooking byproducts, helping the hood clear steam and smoke and reduce lingering kitchen odors.

• Filters air when the hood is set up for non-ducted/recirculating operation
• Helps capture fine particles from cooking to reduce haze and odors
• Replace if saturated, warped, damaged, or excessively discolored
• Common symptoms of a spent filter set: lingering odors after cooking, smoke not clearing as well, visible buildup on filters

• Disconnect power to the hood and allow components to cool before servicing
• Access filter area (location and retention method vary by model); note orientation of existing filters
• Release tabs/latches, remove old filters, and seat the new filters securely in the same orientation
• Refer to your model's use & care guide for specific replacement guidance and intervals

The Filter is an OEM part for Whirlpool ranges. Installed at the base of the downdraft vent opening, this filter works to capture grease, smoke and odor particles emitted during cooking.

Causes of a bad filter can include natural saturation over many uses as it accumulates grease residue. Extremely high-heat or splattering cooking methods may also accelerate the clogging process.

Symptoms of an inefficient range downdraft filter include:

• Grease residue visible below the vent opening or on surrounding cabinetry
• Reduced effectiveness at extracting smoke, odors or steam from cooking surfaces
• Vent motor or fan starting to strain or make louder noises during use

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Color: chrome. Size: 7 5/8 x 5 inch. For charcoal grease filter use 4359331.

Includes one microwave vent filter. Color: metallic. Measures about 6 inches wide by 11-1/2 inches deep.

This adapter tube assembly connects sections of the appliance's water line to create a secure, leak-resistant path for water flow. Replace it if the tube is cracked or the connection no longer seals properly to prevent leaks and restore flow.

• Connects water tubing between components within the appliance's water system
• Helps maintain a tight, leak-resistant seal at the joint
• Restores proper water flow when a tube or connector is damaged
• Typical symptoms: water leaking at the connection, reduced or no water flow, visible cracks/kinks, loose fit

• Disconnect power and shut off the water supply before servicing
• Relieve line pressure and place a towel or pan to catch any residual water
• Note routing and orientation before removal to ensure correct reassembly
• After installation, restore water and check all connections for leaks

Color: metallic. Measures about 11-1/2 inches wide by 12 inches deep.

Color: metallic. Measures about 5 inches wide by 12 inches deep.