Whirlpool Switch

Color: White

This control switch completes the electrical connection for a specific function on the appliance, restoring reliable on/off or selection control. Replacing a worn or failed switch helps return normal operation and user control. What it does

• Acts as the user control to open or close the electrical circuit for a specific function
• Common symptom: appliance function won't start or respond when the control is pressed or turned
• Common symptom: intermittent operation or loss of control for the affected feature
• Replaces a burned, stuck, or electrically failed switch to restore consistent control

• One replacement control switch

• Disconnect power (unplug appliance or turn off circuit breaker) before starting any repair
• Verify correct switch orientation and wiring location before removing old part; label wires if needed
• Use basic hand tools; avoid forcing connectors — inspect for damaged harnesses or terminal tabs

The Push to Start Switch is an OEM component designed for Whirlpool electric dryers. Located on the control panel, the start switch initiates and stops each drying cycle upon button depression. Its electronic components coordinate power to the drum motor and other functions.

Symptoms of a bad start switch include:

• The dryer failed to start despite selecting the settings  
• Inability to cancel or pause cycles in progress
• Intermittent or unreliable response when pressing the button
• Lights or displays functioning but the drum remains motionless

Causes can involve normal wear over thousands of uses wearing out integrated circuits and connections. Water intrusion may lead to early failure.

This OEM Whirlpool part is also compatible with KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore dryer models. 

This switch completes or interrupts an electrical circuit to control a function in the appliance, restoring normal operation when the original switch fails. It provides a direct replacement designed to match the appliance's control assembly. What it does:

• Opens or closes a circuit when pressed to activate the associated function
• Replaces a worn or failed switch that causes unresponsive controls
• Commonly linked to symptoms such as no response from the affected control, intermittent operation, or the function not engaging
• Works as a mechanical/electrical interface between user input and the appliance control

• One switch

• Disconnect power to the appliance before servicing to avoid shock or injury
• Access may require removing a control panel or trim; retain fasteners and note wiring locations
• Unplug the connectors or carefully remove terminals; install the new switch and reattach wiring exactly as found
• Test the appliance function after reconnection

This running capacitor restores proper motor operation by providing the phase shift needed for fan and compressor motors. It helps motors run smoothly and reduces overheating or hard-start symptoms when the original capacitor fails. What it does:

• Provides the steady electrical phase shift required for motor operation in refrigeration and HVAC systems
• Helps restore normal motor starting and running performance
• Can reduce motor overheating, humming, or intermittent operation caused by a bad capacitor
• Used when the motor runs poorly, won't reach full speed, or cycles unusually

• 1 running capacitor

• Disconnect power at the breaker and verify the appliance is de-energized before servicing
• Discharge the capacitor with an insulated tool and wear insulated gloves and eye protection
• Replace with the same type and mounting orientation; secure all wire connections firmly