Crosley Gasket & Seal

The Door Gasket is an OEM part for Frigidaire refrigerators. It ensures a tight seal around the door, preventing cold air from escaping and maintaining the set temperature inside the appliance. Over time, the gasket can wear out, become brittle, or lose its elasticity, leading to gaps between the gasket and the appliance frame. The gasket measures approximately 31" x 60"

Causes of a bad door gasket can vary from normal wear and tear to accidental damage. 

Symptoms of a bad Gasket include:

• Noticeable gaps or tears in the gasket
• Difficulty in maintaining the set temperature
• Condensation or frost buildup around the door

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

The Refrigerator Door Gasket is an OEM part for Frigidaire refrigerators. It lines the edge of the refrigerator door, creating an airtight seal that prevents warm air from entering and cold air from escaping the unit. This seal is crucial for maintaining the efficiency of the refrigerator, ensuring that it runs smoothly and keeps food at the correct temperatures without overworking the cooling system.

Symptoms of a bad Refrigerator Door Gasket include:

• Visible cracks, splits, or wear in the gasket material
• Condensation or frost build-up around the door edges
• The refrigerator door not closing fully or seeming to have air leaks

Causes of a bad door gasket can stem from natural degradation over time, exposure to food oils and residues that degrade the rubber, or deformities caused by improper door usage or accidents.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This freezer door gasket is an OEM replacement part for Frigidaire refrigerators. The gasket measures approximately 28" wide x 18" long. This gasket is a perfect fit for your refrigerator's inner door panel.

Symptoms of a bad freezer door gasket include:

• Difficulty keeping interior cold temperatures below 0°F  
• Frost buildup around top and sides of door seals
• Defrosts required increasing in frequency
• Visible air gaps noticeable along gasket perimeter

Causes of a bad freezer door gasket can include material breakdown due to hundreds of door opening and closing compression cycles over time developing small cracks in the rubber. Spills along bottom edges may promote seal deterioration if not cleaned promptly.

This genuine Frigidaire replacement gasket is compatible with other brands such as Electrolux and Kenmore as well 

NOTE: To achieve a smooth installation, simply soak the gasket in warm water or use a hair dryer on low heat to eliminate any folds or creases.

The Freezer Door Gasket is an OEM part for Frigidaire freezers. This part creates a seal around the freezer door to prevent warm air from entering and cold air from escaping, ensuring the freezer maintains its optimal freezing temperature. The gasket is made from a durable rubber material designed to conform tightly against the freezer frame when the door is closed. 

Over time, freezer door gaskets can wear out, become brittle, or lose their elasticity, leading to gaps and leaks in the seal.  

Symptoms of a bad Freezer Door Gasket include:

• Visible cracks or tears in the gasket
• Condensation or frost buildup around the door edges
• The freezer runs more frequently or for longer periods
• Difficulty in maintaining the set freezer temperature
• Increased energy bills due to the freezer working harder

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

The Dryer Drum Felt Seal is an OEM part for Whirlpool dryers. It functions as a barrier, preventing hot air from escaping the dryer drum and ensuring that clothes are dried efficiently. This felt seal is located along the edges of the drum, creating a soft seal that also reduces noise and vibration during operation. For adhesive order WPY055980.

Causes of a bad dryer drum felt seal can include wear and tear over time, exposure to high temperatures that degrade the material, or physical damage from overloading the dryer.  

Symptoms of a bad Dryer Drum Felt Seal include:

• Clothes taking longer to dry or not drying completely
• Increased lint outside the lint filter area
• A noticeable gap between the dryer drum and the door
• Excessive noise or thumping sounds during operation

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

The Agitator Bolt Washer is an OEM part for Whirlpool washing machines. It sits beneath the agitator bolt, providing a secure and tight seal to ensure the agitator remains firmly attached to the drive shaft. This washer plays a crucial role in the smooth and effective operation of the agitator during the wash cycle.

You should replace this agitator bolt washer if it becomes worn out, cracked, or lost. Causes of a bad washer can include regular wear and tear, exposure to harsh detergents, or high levels of agitation that can degrade the material over time.

Symptoms of a bad agitator bolt washer include:

• The agitator being loose or wobbling during the wash cycle
• Unusual noises coming from the agitator area
• Ineffective washing performance
• The agitator not staying in place

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Lower Felt Seal is an OEM part for Frigidaire dryers. This part creates a tight seal between the drum and the front panel, preventing air leakage and reducing energy consumption.

Symptoms of a failing Lower Felt Seal include:

• Clothes getting snagged or caught during the drying cycle
• Increased drying times due to heat escaping from the drum
• Excessive noise or squeaking as the drum rotates
• Visible wear, tears, or gaps in the felt seal

Causes of a bad lower felt seal can include regular wear and tear from the constant rotation of the drum, physical damage from overloading the dryer, or deterioration due to exposure to heat and humidity over time.

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator, and some Kenmore models.

The Blower Housing Seal is an OEM part for Whirlpool dryers. This seal is strategically placed around the blower housing to prevent air leaks, which can reduce the efficiency of your dryer by allowing heated air to escape and drawing in unheated air. A proper seal ensures optimal air flow and temperature regulation within the dryer, contributing to faster drying times and reduced energy consumption. 

Symptoms of a failing blower housing seal include:

• Increased drying times due to inefficient heat use
• Unusual noises from air escaping the blower housing
• Excess lint escaping into the dryer cabinet, which could lead to maintenance issues

Causes of blower housing seal degradation typically involve wear and tear from regular use, exposure to high temperatures that can cause the material to harden and crack, and improper installation that can lead to premature failure.

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Drum Glide is an OEM part for Frigidaire dryers. It is designed to support the front of the dryer drum as it rotates, allowing the drum to turn smoothly with minimal friction and noise. This is a single glide. Your dryer uses two so it is recommended to replace both at the same time.

Causes of a bad drum glide can include wear and tear from regular use, excessive loads that put undue strain on the drum and its components, or accumulation of lint and debris that can interfere with the glide's movement.

Symptoms of a bad Drum Glide can include:

• Unusual noises, such as screeching or squealing, during operation
• Increased difficulty in turning the drum, leading to longer drying times or incomplete cycles
• Visible wear or damage to the glide itself, indicating it is time for a replacement

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

The Seal is an OEM part for Whirlpool dryers. This specific seal is designed to fit around the blower housing, ensuring a tight seal that prevents air leaks within the dryer. The blower housing is a critical component of the dryer's air circulation system, which moves air through the drum to dry clothes efficiently. 

Causes of damage to the Seal can include wear and tear from regular use, excessive heat degrading the material over time, or improper maintenance practices that can cause physical damage to the seal.

Symptoms of a bad Seal include:

• Longer drying times than usual
• Excessive heat buildup in the dryer
• Unusual noises from the dryer, such as rattling or buzzing

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

The Fresh Food Door Gasket is an OEM replacement part for Frigidaire refrigerators. This component forms a critical seal between the refrigerator door and cabinet, helping to maintain the desired temperature and prevent cool air from escaping.

Symptoms of a failing fresh food door gasket may include:

• Difficulty closing the refrigerator door properly
• Warm air entering the fresh food compartment
•  Increased energy consumption due to loss of cooling efficiency

Causes of needing to replace the fresh food door gasket can include normal wear and tear over time, physical damage or tears in the gasket material, or improper door alignment preventing a tight seal.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore refrigerator models. 

Note: If your original door seal was rubber, please note that the factory has changed this to a fiberglass seal. The factory also recommends adhesive part# WPY055980 to install. 

The Dryer Door Seal is an OEM part for Whirlpool dryers. It forms a tight seal around the dryer door, preventing heat and moisture from escaping during the drying cycle. This helps maintain optimal drying efficiency and protects the surrounding components from excess moisture.

Causes of a bad dryer door seal can include wear and tear from regular use, damage from repeated opening and closing of the door, or degradation due to exposure to high temperatures over time.

Symptoms of a bad dryer door seal include:

• Heat escaping from the dryer
• Longer drying times
• Moisture buildup around the dryer door
• Visible cracks or gaps in the seal

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Upper Felt Seal is an OEM part for Frigidaire dryers. It provides a seal between the dryer drum and the front panel, helping to retain heat and ensure efficient drying performance. This felt seal also minimizes friction between the drum and the front panel, reducing wear on the drum and the appliance itself. The seal measures approximately 16.5" long x 1" wide. The adhesive is included as well.

Causes of a bad upper felt seal can include wear and tear over time, exposure to high heat, or damage from foreign objects caught in the drum. A compromised felt seal can lead to inefficient drying and increased energy consumption.

Symptoms of a bad upper felt seal include:

• Clothes taking longer to dry
• Excessive lint accumulation inside the dryer
• Unusual noises during the drying cycle
• Visible damage or gaps in the felt seal

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Also available in maintenance kit: Part Number 5304457724.

The Shaft Seal is an OEM replacement part for Whirlpool washing machines. It is designed to create a watertight seal around the tub shaft, preventing water from leaking out during the wash cycle. This seal ensures the proper functioning of the washer by maintaining the integrity of the water containment within the machine.

Over time, the shaft seal can degrade due to continuous exposure to water, detergent, and the mechanical stresses of the wash cycles. This wear and tear can lead to the seal becoming brittle or cracked, compromising its ability to prevent leaks. Additionally, improper installation or misalignment can also cause the seal to fail prematurely.

Symptoms of a bad shaft seal include:

• Water leaking from the bottom of the washing machine
• Excessive moisture or pooling water around the washer
• Unusual noises during the spin cycle
• Visible cracks or damage to the seal itself

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Gasket, Fresh Food Door is an OEM part for Frigidaire refrigerators. It is essential for creating a tight seal around the door of the refrigerator's fresh food compartment, preventing warm air from entering and cold air from escaping. This seal helps maintain the internal temperature, ensuring food stays fresh longer and the refrigerator operates efficiently. The gasket measures approximately 37 inches in length and 29 inches in width. 

Symptoms of a bad Fresh Food Door Gasket include:

• Condensation or frost buildup inside the refrigerator,
• The refrigerator running more frequently or for longer periods,
• Difficulty maintaining consistent temperatures in the fresh food compartment.

Causes of gasket failure can include normal wear and tear, exposure to harsh cleaning chemicals that degrade the material, or damage from frequent use.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

The Door Seal is an OEM part for Whirlpool dryers. It forms a tight seal around the dryer door, preventing heat from escaping and ensuring efficient drying performance. This seal helps to maintain the internal temperature of the dryer, optimizing energy use and improving drying results.

Causes of a bad door seal can include wear and tear from regular use, damage due to improper handling or cleaning, or deterioration over time. A compromised door seal can affect the efficiency of the dryer and lead to potential safety issues.

Symptoms of a bad door seal include:

• Heat escaping from the dryer door
• Longer drying times
• Higher energy consumption
• Visible wear or damage to the seal

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.