Crosley Refrigerator Parts

The right door on our Jenn Air French Door Refrigerator would pop open & not fully close when the left door was closed first. Called the local distributor/dealer who advised me that the magnetic door gasket probably needed replacement (cost $300.00 + for the repair) What??? Visited you web site where I noted the right door had a "closure & bushing" on the bottom of the door. Could it be this was the problem fix? Took the right door off & examined both pieces. Sure enough the bushing was... Read more

• Ice maker dispenses too much ice
• Leaking
• Ice maker not making ice

Watched online video and worked along - it was easy and quick - I was amazed! Read more

Purchased a new starter and compressor run capacitor. Unplugged appliance from wall outlet. removed clip that holds these item in place. unplugged starter from compressor and from electrical wiring. plugged capacitor into starter, then plugged the electrical connection into assembly. Plugged starter into compressor. Plugged the appliance into wall outlet and the unit was running again Read more

• Not dispensing water
• Ice maker not making ice

Replaced the water inlet valve. Easy to do. Followed the video, which was the exact way to do it. Don't be confused by the other valve. Read more

I called Appliance Parts Pro told them what I needed it and the model of the refrigerator. They told me exactly what I needed and also made suggestions to make sure I had enough parts to accomplish the task. Read more

I ordered the new replacement housing and switched it out. Read more

Although the solenoid I purchased did not fix the problem, nor the "mother electronic board", or the motor, my experience with Appliance Parts Pros has been excellent. Extremely easy to look-up parts for my model refrigerator. Best part is their video instruction that gives you step-by-step hands-on how to remove and install. I would highly recommend these folks. If a lady such as myself can do repairs based on their instruction, anyone can. Thank you for providing such an informative... Read more

• Ice maker won't dispense ice

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

Ordered door bar and dairy tray cover from you, parts came next day. They slid/napped right in. To everyone: If you can change a roll of toilet paper, you can do this repair. Read more

• Light not working

Ordered switch....turned out it was the socket that was bad...ordered socket.....quick install....light works Read more

Had a friend who is an appliance repair tech. Replace the evaporator, the heater coil, and the filter/drier. Parts were soldered together and the compressor was put under vacuum. Then, charged with 5 oz. of refrigerant. The freezer works great now! Read more

Well, I took it out (it slides out) to get a good look at it,so i could ref pictures on your site..naturally I had serial/model of refrig,and thats mandatory to get the right part. It came in 2 days,,and being just the bucket, it took only a few minutes to transfer the auger assembly/cube/crusher.... into the new one, 6 screws total..Your site has excellent vids on DIY.......I HIGHLY reccomend. Whole process was'nt over 15 minutes, piece of cake....And NOW i can go back to my nightly 'scotch... Read more

Bought OEM replacement part. The new part had all the retaining clips that had broken off of old part. Needed new stick-on label to dress up the replacement shroud. Hardest part of the repair was disconnecting the wired module on back of old shroud. Feared I might snap off those retaining clips, too! Best part of experience of AppliancePartsPros.com was the help received to confirm parts ordered were grey to match the original install on stainless steel Frigidaire. Read more

There is nothing you can't do given the right YouTube video! We disassembled the bottom mount freezer n our Jenn Air refrigerator to remove all the ice and then located the clogged grommet on the back of the unit and cleared it and added a notch. In the process of reassembling we broke the bracket on a part that should have been the easiest portion of the entire installation! In seconds we located and ordered the part on your site. It arrived in a couple of days and then we removed the door and... Read more

I ordered a refrigerator door hinge, hinge pin, and washer. The descriptions and pictures imply that these items are sold separately. However, the hinge I received was an assembly that included a pin and washer. I replaced the original hinge assembly with the new assembly, but the door still sagged (not as badly as before). I added the washer I had ordered separately and the original washer (total of 3 washers). The refrigerator doors seems to be closing properly now. I still have an extra... Read more

Replaced evaporator heater and housing. Just make sure you also replace the thermostat. If not it is a little challenging to get the wires out of the old thermostat/ heater plug into the new plug. Also if you have the same problem be prepared to have a good heat gun to melt the ice buildup around the evaporator and drain hole. The ice build up was so bad that it destroyed the evaporator cover and was leaking into the refrigerator or should I say ice was forming below the evaporator cover... Read more