Dishwasher Screws, Nuts, Washers

This flat metal washer provides a durable spacer and load-bearing surface to secure fasteners in the appliance, helping maintain proper alignment and reduce loosening over time. What it does:

• Distributes bolt or screw load to protect mating surfaces and prevent pull-through
• Helps keep assemblies tight to reduce vibration and rattling
• Maintains spacing where specified in the original hardware stack
• Commonly replaced when worn, bent, or missing to restore secure fastening

• One flat metal washer as shown

• Replace only with the exact washer size and thickness specified by the manufacturer
• Inspect adjacent fasteners and threads; replace any damaged hardware
• Tighten fasteners evenly and to manufacturer guidance; avoid over-tightening
• Disconnect power and follow safety procedures before servicing the appliance

A cage nut used to secure panels, brackets, or components where a captive threaded fastener is needed. Replaces worn or missing clip nuts to restore a solid attachment and prevent loose or rattling parts. What it does

• Provides a captive, threaded anchor for screws in thin sheet metal or slot-style mounting points.
• Holds control panels, trim pieces, or internal brackets firmly in place.
• Helps stop vibrating, rattling, or shifting caused by a missing or damaged nut.
• Allows screws to thread in securely where a weld nut or tapped hole isn't available.

• Always unplug or disconnect power before working on the appliance.
• Access the mounting area and remove any trim or panels blocking the slot or opening.
• Snap the cage nut into the slot or over the edge until it engages; then thread the screw in carefully.

This is a single hex nut used to secure components on Frigidaire appliance assemblies. It provides a reliable threaded connection to hold panels, brackets, or hardware in place and helps prevent vibration-related loosening. What it does:

• Secures mating threaded parts so assemblies stay tight during normal use
• Prevents panels, trim, or brackets from shifting or rattling
• Replaces a corroded, stripped, or missing nut that causes loose hardware
• Works where a standard hex nut is specified by the manufacturer

• Unplug or disconnect power to the appliance before servicing
• Use the correct socket or wrench size to avoid rounding the nut
• Hand-start threads to avoid cross-threading; tighten to manufacturer torque if specified
• Inspect mating bolt/stud for damage and replace if threads are worn