Dishwasher Screws, Nuts, Washers

Flow washer for dishwashers. Seals water flow connections to prevent leaks. Replace if worn, cracked, or missing to maintain proper seal integrity.

Secure dishwasher components with this #8 x 5/8" mounting screw. Replace lost, stripped, or corroded screws to properly fasten panels and parts.

Replacement mounting screw for dishwashers. Secures panels, components, and internal parts. Order a new screw if yours is stripped, missing, or damaged.

This replacement mounting screw secures panels and components in compatible Frigidaire appliances, helping restore stable assembly and safe operation. It's a direct-fit fastener used where the original screw has been lost or damaged. What it does

• Fastens appliance panels, brackets, and small parts to restore secure assembly
• Replaces stripped, rusted, or missing screws that can cause rattling or loose components
• Matches the OEM fit for reliable retention and alignment during normal use

• Use the correct size driver to avoid stripping the head; tighten until snug but do not overtighten
• Disconnect power or follow appliance-specific safety procedures if working near electrical components
• Inspect surrounding hardware and replace as needed

These mounting screws secure assemblies and panels so components stay aligned and stable during normal use. Durable plated steel fasteners help maintain a proper fit and keep parts from loosening over time. What it does:

• Fastens panels, brackets, or components to the appliance frame or assemblies
• Keeps moving parts aligned to prevent vibration and rattling
• Replaces missing or stripped mounting hardware that can cause loose doors or panels
• Used wherever the original mounting screws were removed or damaged

• Turn power off and unplug the appliance before beginning any repair.
• Use the correct screwdriver or bit to avoid stripping the screw head.
• Replace only the screws removed from the same location; match size and thread when possible.
• If a screw hole is damaged or loose, inspect the surrounding area and repair per OEM guidance.

This washer heater assembly heats and maintains wash water temperature to improve detergent performance and cleaning for temperature-sensitive cycles. Designed as a direct replacement part for compatible top- and front-load machines. What it does:

• Heats incoming water to reach selected cycle temperatures for better soil removal.
• Helps maintain water temperature during the wash portion of the cycle.
• Common symptom: washer runs but water stays cold or loads are not cleaned as expected.
• Common symptom: water temperature error codes or washer fails temperature-sensitive cycles.

• Disconnect power and water supply before starting any repair.
• Handle the heating element and wiring with care; avoid damage to terminals and gasket surfaces.
• Installation may require removal of access panels and basic hand tools.
• After installation, restore power and run a short test cycle to check for leaks.

This screw fastens the heater bracket to the appliance, providing a secure mount for the heating assembly. Replacing a worn or missing screw helps keep the bracket stable and maintains proper heater positioning. What it does:

• Secures the heater bracket to the cabinet or housing to hold the heating element in place
• Prevents bracket movement that can cause rubbing or vibration noises
• Reduces risk of intermittent heating caused by a loose heater assembly
• Helps maintain correct alignment of the heater and related components

• Disconnect power (and gas for gas models) before beginning any repair
• Use the correct screwdriver or driver bit to avoid stripping the head
• Handle sharp sheet-metal edges carefully and follow all appliance safety instructions