Electrolux Cable Or Retainer

This retainer is a small fastener that secures a component inside your appliance, keeping it correctly positioned during operation. Replacing a damaged or missing retainer helps eliminate looseness and noise while preventing wear from parts shifting.

• Holds a mating part or assembly firmly in place
• Restores proper fit when the original retainer is cracked, warped, or missing
• Common symptoms: loose or misaligned parts, rattling/vibration, rubbing noises
• Helps prevent premature wear from movement or chafing

• Disconnect power; shut off gas and water supplies if applicable
• Use your model's diagram to locate the retainer and match its orientation
• Transfer any reusable hardware and ensure the retainer is fully seated
• Reassemble and run a short test to check for proper operation

This electrical harness cable connects appliance controls and components to deliver power and signals for normal operation. It replaces a damaged or worn cable to restore reliable electrical connections and reduce intermittent faults. What it does:

• Provides secure electrical connection between control board and components
• Restores signal and power flow when original cable is frayed, pinched, or broken
• Helps stop intermittent operation, failed controls, or non-responsive functions caused by wiring faults
• Matches OEM configuration for plug fit and routing when installed correctly

• Always disconnect power to the appliance before starting any repair
• Compare new cable to the old one for connector type and length before installation
• Route and secure the cable following the OEM routing to avoid pinch points and heat sources

A simple wire-fastening cable tie that secures wiring and small hoses to prevent rubbing, snagging, or loose routing inside the appliance. Helps keep components organized for safer, quieter operation. What it does

• Secures wiring bundles and small hoses to chassis or brackets to prevent abrasion and movement
• Helps stop intermittent shorts or electrical noise caused by wires rubbing or contacting other parts
• Keeps airflow and moving parts clear by holding wiring away from fans and belts
• Useful when replacing or re-routing harnesses during repairs

• Always disconnect power before working on the appliance.
• Loop tie around wiring or hose, pull to secure snugly, and trim excess tail; do not overtighten.
• Replace ties that are brittle or damaged; use the same routing as the original harness.
• Dispose of trimmed ends and avoid sharp edges that could cut wiring insulation.

This retainer secures appliance panels and components to keep assemblies aligned and stable, restoring proper fit and reducing noise or vibration. Use when a clip or bracket has broken, come loose, or no longer holds parts in place. What it does:

• Holds trim, panels or internal components in position to prevent rattling and misalignment
• Replaces worn or broken clips that allow gaps or loose parts
• Helps restore a snug fit after service or component replacement
• Works as a simple fastener to maintain proper assembly alignment

• Disconnect power to the appliance before beginning any repair
• Installation typically requires basic hand tools; handle small clips carefully to avoid losing them
• Inspect surrounding clips and mounting points and replace any damaged hardware

This bushing protects the appliance service cord where it passes through the cabinet, reducing wear and preventing chafing that can expose wiring. It's a simple replacement that restores a safe cord entry point. What it does:

• Cushions and centers the service cord at the cabinet opening to prevent abrasion
• Helps keep the cord from rubbing on sharp metal edges that can cause insulation damage
• Reduces risk of shorting, sparking, or intermittent power caused by a worn cord
• Commonly replaced when the existing bushing is cracked, missing, or deformed

• One service cord bushing

• Disconnect power (unplug or switch off breaker) before servicing
• Inspect the cord and surrounding insulation; replace the cord if damage is found
• Push the bushing into the cabinet opening, then route the cord through the bushing until seated
• Reuse only if undamaged; do not force a damaged bushing into place