Electrolux Latch, Catch, Lock Parts

Fix a dryer door that pops open during the cycle with this door latch striker. Restores secure door engagement. Takes under 5 minutes to install.

Fix a microwave door that won't close or sticks when opening. This latch hook secures the door mechanism for proper sealing. DIY repair in under an hour.

Washer won't start or advance to spin cycle? A broken lid strike prevents the lock from engaging. Simple 5-minute snap-in fix—just remove two screws.

Fix an oven door that won't lock during self-clean or clean cycle errors. This door latch assembly secures the door and reports lock status to the control.

The Latch is an OEM replacement part for Frigidaire built-in microwaves. Securely mounted to the top interior section of the microwave cavity door, the positive-locking latch holds the door safely shut during operation. Crafted from corrosion-resistant materials for extended use, the latch handle withdraws the hook mechanism with a simple pull to conveniently access food within.

Symptoms of a bad latch include:

• The microwave door popping or falling open unexpectedly  
• Difficulty closing or fully engaging the secure latch hook 
• Wear signs like loose mounting points or a worn handle

Causes can involve repeated opening/closing cycles gradually loosening mounting fixtures, or parts rendered ineffective by moisture intrusion over time.

Replacing this Frigidaire OEM latch prevents potential microwave door opening during cooking cycles. Compatible with Electrolux, Gibson, Kelvinator, and Kenmore built-in models.

Fix a warm fridge or frost buildup with this door gasket magnetic strip. Restores the seal when cold air escapes. Easy DIY repair in under 30 minutes.

Microwave door won't close or latch properly? This door latch hook secures the door and restores normal closing. Simple DIY fix in under 15 minutes.

This replacement magnet is used in select refrigerator assemblies. It provides the magnetic hold or sensor trigger required so doors, flaps, or rails stay closed and so the controls can accurately detect when components are in position.

• Supplies magnetic retention in the specified assembly to keep parts closed and aligned
• Activates magnetic reed sensors in models that use them for door/position detection
• Weak or missing magnets can lead to door-ajar alerts, air leaks, or components not staying shut
• Visible damage or incorrect orientation can cause intermittent operation or improper sealing

• Disconnect power before servicing; turn off water if working near the dispenser
• Use your model's parts diagram to locate the magnet and note its orientation/polarity
• Press-fit into its holder carefully; do not chip or crack the magnet
• Verify proper closure/sensing operation before returning the appliance to service

This latch secures the detergent or fabric softener dispenser drawer on a front-load washing machine, keeping it firmly closed during the wash cycle. It clicks into place to hold the drawer shut and releases when pressed to allow access to the dispenser compartments. Replace this latch if the dispenser drawer will not stay closed, pops open during a cycle, or if the latch mechanism is cracked or broken.

Fix a refrigerator door that won't close or stay shut with this door latch. Simple repair that restores proper door seal and cooling efficiency.

Fix a microwave door that won't stay closed with this door latch replacement. Restores safe operation when the door won't latch properly. DIY-friendly.

Drawer won't stay closed? This door catch magnet secures your warming drawer, ensuring a tight seal. Direct replacement restores reliable closure.