Frigidaire Dishwasher Gasket & Seal

This tub guard protects the washer tub rim and helps prevent clothes from catching or tearing at the top edge. It restores a smooth tub opening and reduces fabric wear for safer, quieter loads. What it does:

• Covers and smooths the exposed tub rim to stop fabric snags and tears
• Helps reduce noise and vibration caused by contact between clothing and the tub edge
• Maintains a finished appearance at the washer drum opening
• Works with the existing tub seal and trim to improve load handling

• One tub guard

• Disconnect power and turn off water before starting any repair
• Remove the washer agitator or top panel only if required for access; follow your model's service instructions
• Align the guard with the tub rim and press into place until it snaps or seats evenly; ensure the seal is continuous
• If any clips or screws are present, reinstall securely; discard damaged guards and replace with correct part

This door gasket is the flexible rubber seal that closes the refrigerator door, helping keep cold air in and reduce energy loss. Replacing a worn or torn gasket restores a tight seal and helps the appliance maintain proper temperature. What it does:

• Seals the cabinet to keep cold air inside and warm air out
• Helps maintain consistent fridge/freezer temperature and efficiency
• Reduces frosting and moisture buildup caused by leaks
• Commonly needed when the seal is cracked, torn, warped, or no longer mates flush with the cabinet

• One replacement door gasket

• Clean the door flange and gasket mounting area before installing to ensure a proper seal
• Inspect for mounting clips or retainer channel; follow appliance-specific alignment steps for a snug fit
• Warm the gasket slightly (per OEM guidance) if needed to ease installation — avoid open flames or excessive heat

This pump gasket seals the connection between the appliance pump and housing to help prevent leaks and keep water flowing where it should. A simple replacement that restores a watertight pump interface. What it does:

• Creates a tight seal at the pump housing to stop water from leaking
• Helps maintain proper drain flow by preventing bypass leaks
• Commonly replaced when you see puddling or moisture under the appliance
• Can prevent intermittent draining issues caused by a compromised seal

• One pump gasket

• Disconnect power and water supply before starting any repair
• Inspect mating surfaces and clean debris before installing the new gasket
• Ensure the gasket seats fully and pump/housing fasteners are torqued to spec

This O-ring is a small rubber sealing gasket that prevents water leaks at a refrigerator water connection. It restores a watertight seal to stop drips and maintain proper water flow to the dispenser/ice system. What it does:

• Creates a watertight seal at a water line or valve connection
• Helps stop visible dripping or slow leaks from fittings
• Maintains proper pressure and flow by preventing bypass around a joint
• Used where a compressible seal is required between two mating parts

• Shut off water supply and disconnect power before servicing
• Replace only with the correct-size O-ring and seat it evenly in the groove
• Inspect mating surfaces for nicks or debris; clean before installing the new O-ring
• Tighten fittings to manufacturer torque recommendations to avoid over-compression

This replacement door gasket creates a tight seal around the refrigerator door to help maintain proper cooling and reduce energy waste. It restores the door's sealing surface for more consistent temperatures and less moisture buildup. What it does:

• Seals the door perimeter to keep cold air in and warm air out
• Helps prevent frost and ice buildup inside the compartment
• Reduces excessive run time from the compressor caused by air leaks
• Minimizes condensation and food spoilage linked to poor door sealing

• Disconnect power to the appliance before starting any work
• Remove the old gasket and clean the gasket channel and mounting surface
• Align and seat the new gasket evenly around the door; start at corners for best fit
• After installation, allow the gasket to set and check for gaps; adjust as needed