Frigidaire Dishwasher Parts

Fix a dishwasher that won't drain or hums during drain cycle. This drain pump assembly removes standing water and completes wash cycles. Moderate DIY repair.

Sound dampening insulation blanket that installs inside the dishwasher cabinet. Replace if missing, torn, or deteriorated to restore quiet operation.

Routes water between internal dishwasher components. Replace this hose if cracked, leaking, or worn to prevent water damage and maintain proper flow.

Covers the gap beneath the dishwasher door at the base. Replace this lower toe kick panel when the original is dented, cracked, or missing to restore a clean, finished appearance.

Plastic stop cap that secures the upper dishrack rail track in your dishwasher. Replace if broken, cracked, or missing to keep rack sliding smoothly.

Replace your cracked, broken, or missing dishwasher silverware basket. Restores organized utensil storage and keeps flatware secure during wash cycles.

Traps food particles and debris to prevent drain clogs. Replace when cleaning performance declines or odors develop. Verify fit with your model number.

Dishwasher drain hose connects the pump to your sink or disposal. Replace if cracked, leaking, or damaged to prevent water backflow and leaks.

Fix a dishwasher that won't spray water or makes loud grinding noises with this circulation pump motor. Repair takes 45 minutes to 2 hours for DIYers.

This seal kit includes the gaskets and sealing components that fit between the dishwasher tub and the outer cabinet. These seals prevent water from leaking out of the wash compartment during operation. Replace this kit if you notice water pooling underneath or around the sides of the dishwasher during a wash cycle.

Fix dishwasher leaks or poor drainage with a new sump assembly. This pump housing restores proper water circulation and stops leaks from cracks or clogs.

Retainer clip secures dishrack components in position. Replace if your dishwasher's clip is cracked, bent, or missing to restore proper fit.

This is the user control and display board located on the front panel of the dishwasher. It contains the buttons, display, and interface circuitry that allow you to select wash cycles, options, and monitor cycle status. Replace this board if the display is blank or flickering, buttons are unresponsive, or the dishwasher does not respond to cycle selections.

Threads onto your sink faucet to connect a portable dishwasher's quick-connect hose. Replace if cracked, stripped threads, or missing the original adapter.

Front-mounted dishwasher control panel with touch pad buttons and display. Replace when buttons stop responding, panel is cracked, or display is damaged.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating