Frigidaire Trim

This front wire shelf trim replaces the finished edge that attaches to a refrigerator wire shelf, restoring a secure, finished front edge and preventing items from catching or sliding off. Fits a 26.8" wire shelf front. What it does:

• Replaces damaged or missing front trim to restore shelf edge alignment and appearance
• Helps keep stored items from sliding off the front of the shelf
• Provides the correct mounting edge so the shelf locks into place properly
• Useful when the existing trim is cracked, bent, or worn

• One front wire shelf trim (26.8")

• Basic snap-on or screw-in installation; refer to your model's diagram for exact fasteners
• Remove food and loose items from the shelf before replacing trim
• Wear gloves to protect hands from sharp shelf wires during installation
• If fasteners are missing or damaged, inspect the shelf and order replacement hardware as needed

Replace your oven's control panel trim if it's cracked, chipped, or missing. This decorative trim piece frames the control panel for a finished look.

White upper oven door trim piece that frames the door window. Replace if cracked, discolored, or broken to restore your oven's appearance and seal.

Black upper oven door trim piece that frames the door window. Replace this cosmetic trim if it's cracked, chipped, discolored, or missing from your oven.

Black top trim piece for wall ovens. Covers the gap between the oven and cabinet for a finished look. Replace if cracked, chipped, or missing.

A black top canopy trim that restores the finished edge at the top of the appliance for a clean, uniform appearance. Designed to replace damaged or missing trim and refresh visible surfaces. What it does:

• Covers and protects the top canopy edge, hiding mounting hardware for a neater look
• Replaces cracked, chipped, or warped trim that affects appearance
• Helps maintain the original fit and alignment of the canopy assembly
• Designed to match original OEM fit, finish, and mounting points

• Disconnect power to the appliance before starting work
• May require removing adjacent trim panels or fasteners for access
• Use the original mounting screws or clips; inspect hardware for wear and replace if needed

This bodyside trim is a white decorative and protective strip that finishes the refrigerator cabinet edge for a clean appearance and helps protect the side from nicks and wear. It restores the factory look after repair or replacement. What it does:

• Covers and protects the cabinet side edge to reduce dings and cosmetic damage
• Provides a finished, factory appearance for the refrigerator exterior
• Helps maintain a consistent seal/fit where the cabinet meets exterior panels
• Replaces damaged, faded, or missing trim to improve overall aesthetics

• One white bodyside trim

• Unplug the appliance or disconnect power before beginning any service
• Remove any adjacent panels or fasteners as required to access trim mounting points
• Align tabs/snaps and press firmly into place; do not force or bend plastic

This trim is the replacement front trim piece that finishes and protects the crisper cover area, restoring a clean edge and helping the crisper drawer sit and seal properly. Ideal when the existing trim is cracked, chipped, or missing. What it does:

• Replaces damaged or missing crisper cover trim to restore appearance and edge protection
• Helps the crisper cover align with the drawer opening for a better fit
• Prevents sharp edges and keeps food-contact areas looking finished
• Addresses symptoms like visible cracks, chipped trim, or a loose-looking crisper cover

• One trim piece for the crisper cover (single unit as shown)

• Disconnect power to the appliance before servicing to avoid electric shock
• Remove the crisper drawer and cover per the appliance service instructions; install trim by aligning and snapping or fastening into place
• Handle with care to avoid scratching or chipping the cover; do not force parts into place