General Electric Dryer Parts

Side vent kit for dryers that redirects exhaust airflow to the side instead of the rear. Needed when rear venting isn't possible due to space constraints.

Seals your dryer door to prevent heat loss and improve drying efficiency. Replace if torn, cracked, or no longer sealing properly. Confirm fit with your model.

This molded wire tie standoff provides a secure anchor point for a cable tie to hold wiring and harnesses away from moving parts and hot or sharp surfaces, helping reduce wear and electrical risk. Fits common HVAC and appliance wiring panels. What it does:

• Anchors wire ties to the appliance cabinet or chassis so harnesses stay routed and secured
• Prevents wires from rubbing on sharp edges, hot components or moving parts
• Helps stop intermittent electrical issues from loose or vibrating connections
• Reduces noise from loose wiring that can vibrate during operation

• One wire tie standoff

• Disconnect power before servicing the appliance to avoid shock or damage
• Mount in the original standoff hole or approved panel location; secure a cable tie through the top loop to hold the harness
• Use the correct fastener or snap method for your model—do not force or overtighten
• If routing or attaching multiple wires, verify clearance from heating elements and moving parts

Gas supply pipe for dryers. Connects the gas valve to the burner assembly. Replace if cracked, corroded, or leaking to restore safe gas flow to your dryer.

Plastic flat drive belt for dryers. Transmits motion between components. Replace if worn, cracked, broken, or slipping to restore smooth operation.

Replace a worn, broken, or damaged dryer idler arm. This structural part holds and tensions the belt around the motor pulley and drum in your dryer.

Dryer drum light bulb assembly illuminates the interior during operation. Replace when bulb burns out or light stops working. Verify fit with your model.

Wire harness that connects the dryer control panel to the electronic control board. Replace if wires are damaged, connectors are broken, or harness is worn.

This is the complete dryer door assembly, including the door frame and inner panel. It serves as the main access point to the dryer drum, sealing the drum during operation to maintain proper airflow and heat. Replace this assembly if the door is cracked, warped, won't latch properly, or if the dryer stops mid-cycle due to a faulty door switch connection.

Dryer drum belt rotates the drum during cycles. Replace if drum won't turn, makes squealing noises, or belt shows wear. Confirm fit with your model number.

Dryer not heating or won't ignite? This gas valve and pipe assembly controls propane flow to the burner. Common fix for no-heat issues on gas dryers.

White touch pad trim for dryer control panels. Replace this cosmetic trim piece if it's cracked, chipped, discolored, or missing from your unit.

Mounting plate that secures the coin box assembly on commercial dryers. Replace if cracked, bent, or missing to restore a stable, aligned mount.

Elbow and nozzle assembly for dryers. Connects ductwork and directs airflow. Replace if cracked, broken, or missing to restore proper ventilation.

Replacement mounting screw for dryer front panel assembly. Secures front panel to cabinet. Needed when original screw is stripped, missing, or lost.