Need Help?
Call or text
Replacement door latch lever bracket for microwaves. Installs behind the control panel to hold interlock switches. Needed when bracket is cracked or broken.
Ordered new switches (replaced all three- upper and lower door switches and switch monitor- just to make everything new). Received them within 48 hours! You tube video enabled replacement job to be completed by handyman neighbor in 20 minutes (would have been shorter repair time but for my kibitzing). Appliance Parts Pros gets an A+! Will do business with APP on any future appliance repairs! Read more
Microwave completely dead or showing F1 error code? This oven cavity thermal cutoff sensor prevents overheating. Moderate DIY repair, test with multimeter.
GE Microwave/Convection Oven. Removed case (carefully). Tested in-line power cord fuse with multi-meter. Fuse was good. Noticed a scorch mark on a wire connected to the oven cavity thermal fuse. The fuse appeared to have been overheated from too much movement in it's mount. Removed part from unit and used number on the part to order a new one. Installed new part, re-assembled, and unit works fine. Read more
The Microwave Door Latch is an OEM replacement part for GE microwaves. It securely fastens the microwave door when a cooking cycle is activated. A well-functioning latch is important for safety purposes, preventing accidental door openings and potential radiation exposure during operation.
Causes of damage usually involve wear from normal usage over time as the latch mechanism is utilized frequently. Failure can impair safety.
Symptoms of a defective door latch include:
This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.
FOUND THAT THIS IS A DIRECT REPLACMENT FOR THE DOOR LATCH ON MY ADVENTIUM PSA1201RSS 01 MICROWAVE/CONVECTION OVEN. GE SAID THE PART WAS NOT AVAILABLE BUT THIS PROVED THEM WRONG. A $3 PART SAVED A $300 DOLLER DOOR. Read more
Microwave tripping breaker or won't start? Failed door interlock switch is the likely cause. DIY repair in 30-60 minutes with basic tools.
By replacing the switches. Read more
Mica cover that protects the waveguide opening inside your microwave. Replace if cracked, burned, torn, or tabs have broken off during normal use.
Fuses are all OK, but the primary of low voltage transformer was disconnected. Replaced with new one, everything works good. Read more
Replaces a cracked, bent, or missing microwave exhaust damper flap. Installs on top of the unit to direct airflow and prevent drafts when not venting.
Microwave tripping the breaker or won't power on? This thermostat protects against overheating. Common fix when the unit is dead. Moderate DIY repair.
Tried to turn the microwave on, checked the outlet for power, check the breaker to see if it was tripped, all was in order. Removed the over the range microwave and pull the covers, Tested continuity with a multimeter for each of the 4 normally closed thermostats, found 2 bad (open). The upper 110 and the lower right 70. Ordered the needed parts as well as both lamp sockets and bulbs as they where broken too. The parts where correct and where delivered on time. (Also, in your tools needed or... Read more
Replace your cracked, broken, or missing microwave glass cooking tray. This rotating turntable supports food for even heating in your microwave cavity.
Ordered new tray from Appliance Pros Read more
Replacement vent grille that covers the exhaust opening at the top of your microwave. Needed when the original is cracked, broken from impact, or missing.
Ordered a replacement from you. Read more
Traps grease and particles from ventilation air in your microwave. Replace when clogged or damaged for optimal performance. Verify fit with model number.
Took out the old ones and inserted the new ones, extremely easy Read more
Removes grease, smoke, and odors from your microwave's ventilation system. Replace when clogged or discolored. Confirm fit with your model number.
Slid in new ones Read more
Microwave won't heat but runs? A faulty diode cable assembly prevents power conversion. DIYers report 10-minute fixes after diagnosing the issue.
Replaced the high voltage diode. You will need a special Torx screwdriver to remove the tamper resistant screws holding the cover. Once the cover is removed there should be a packet inside containing a schematic and detailed troubleshooting instructions. I used extreme caution to discharge the capacitor. The rest was simple. One screw and a push connector to remove and reinstall the diode. I fired it up and it was good as new. Thanks to AppliancepartsPros for the good guidance and extremely... Read more
Replace your cracked, broken, or missing microwave glass tray. This rotating tray sits on the turntable support to hold food during cooking and heating.
I ordered a new one and got it in two days. It was a perfect match for the old one. Read more
Microwave tripping breaker when door opens or at startup? A failed monitor switch with welded contacts is the likely cause. 30-minute DIY repair.
Replace your burned-out microwave cavity bulb to restore bright interior lighting. Essential when light is dim, flickering, or out completely. Confirm fit with your model number before ordering.
14 year old GE Profile microwave wouldn't heat, but had power. Read reviews here. Ordered triumvirate of magnetron, capacitor, & diode. Was hoping not to need the capacitor as this was an expensive part; and if not needed to return to AppliancePartsPros, which has been SOP. After watching a couple YouTube videos of microwave capacitors being shorted, I made a capacitor discharge tool ordering 24W 100K Ohm resistor and high voltage test wires w/ alligator clips from amazon. At the same time,... Read more
Replacement glass turntable tray for microwaves. Rotates during cooking to heat food evenly. Order a new tray if yours is cracked, chipped, or broken.
And continued to crack more with each use. Ordered a new on. Quick chat online with a rep to make sure I had correct part, ordered and it got here 2 days later. Fantastic!! Read more