General Electric Range / Cooktop / Oven Parts

First took apart my range control panel to review the possible failed component based on the flashing error code I was receiving. Found some insects inside the panel. Cleaned out but this did not work..possible short. Checked online with your chat service and they confirmed the two possible parts I may need. I ordered and replaced the most likely one and that did the trick. Part is working great and it did not take more than an hour to install. Read more

I needed to replace the light bulb in the oven, but forgot to turn off the breaker and unplug the oven (NEVER DO THIS)!!! There was a spark, and my control board was fried. The range top worked fine, so I knew if was the control board (if you no longer see the digital clock and none of the buttons are responsive, it's a pretty good indicator that it's toast). Simple fix. Buy this part, turn off the breaker, unplug the appliance, remove the backing from the unit, remove 4 screws, swap out the... Read more

I ordered a new control online and replaced it in about twenty minutes. Read more

Purchased Burner Bowls at a great price. Installed within minutes of delivery. Read more

We took out the old broken element and unscrewed two screws in side the the oven. And did the same on the back. Read more

I bought a replacement glass piece from Appliance Parts Pros (which was professionally packaged, shipped and delivered in less than a week), checked YouTube for some helpful mechanical information, then replaced it in just over half an hour. Thank you, APP, for keeping these parts in stock! Read more

Replaced the Spark Module Read more

Replaced all gas lines (orifices), electrodes, and the spark module. Now, works like a charm. Not a hard fix at all. First time doing repair, so I took my time. Read more

I repaired the problem by replacing the Power Board assembly and the daughter relay board. Not sure which one was the problem. Since I had it apart I replaced both. So far the unit is working like new. Everything was plug in, so I didn't have to worry about complex wiring. I took pictures prior to disassembly to make sure I got the reassembly right. Worth the effort to fix it- very satisfying. Read more

Replaced element Read more

Just took out old elements and then old pans. Replaced all 4 pans followed by 4 elements. Had to adjust element leads to get a secure level fit. Looked like a new range top when completed. The job was completed in less than 15 minutes. Read more

Replaced spark module and all electrodes/igniters. Read more

I found I could "rap" on my broiler/oven control valve and the oven would light, so I ordered a new control valve. Installing valve was not difficult except for having to lay on the floor and work in a small space. After installation, the oven lit only ONE time...and the boiler/oven problem was unchanged....broiler would light, but not oven. (Both incandescent pilots would glow brightly, so I did not suspect the igniter/pilot.) A friend suggested I swap ignitors anyway...and indeed, the... Read more