General Electric Range Parts

Ordered parts. Unscrewed old handle and screwed in new handle Read more

• Won't start

Did some research to find out it was the electrode. Pulled out the old one to match what was on your site. It came in no time at all, and the replacement was a cinch. Read more

Replaced the oven burner, ignitor, and the safety valve. Read more

Ordered the part on AppliancePartsPros.com - far less expensive than GE, and it arrived in two days. I will definitely use you again. Thank you. Read more

Our 25-year-old range's original Oven Bake Element melted itself. When it happened it looked like someone was using an arc welder in the oven. This seemed to be a potential DIY repair, especially after looking at the cost of a new range. So we Googled the oven's model number (GE JBP21GS2WH) and AppliancePartsPros.com was the top search return. (Way to go, SEO!) Clicking on this link brought up a web page of parts specifically for our model number with the parts sorted by popularity. The Oven... Read more

The glass was easily replaced. Just a few screws to remove cover then remove bad glass then i dropped in the replacement glass then reinstalled cover. Ithen put the door back in the stove. 15 minute job!!! I was so surprised to see how easy it was!!! Thanks! Part fit perfectly!!! Read more

• Element will not heat

Unplug range. Open oven door to gain access to the cook top lock-down screws, located under the front edge of the cook top. Tip the cook top up and carefully remove it by pulling forward. Set aside in a safe place. Remove old, burned-out, element by removing the single lock tab, located on one of the three mounting posts, then lift up. Leave the wiring attached. Flip the element over and remove the three mounting tabs, making note of their numbered locations. Transfer the mounting tabs to... Read more

Replaced spark module and all electrodes/igniters. Read more

Ordered parts from you. Your staff was great and helped me find what I needed! Read more

Replaced the switch infin by watching the video Read more

• Element will not heat

Ordered a new terminal block kit from Appliance Parts Pros. Shipping was lightening fast. Slapped the new part on my stove and its never worked better. Thanksgiving was saved! I'd replace the rest of my stove's terminal blocks if they weren't $50 a piece...sheesh! Read more

• No heat or not enough heat

GE Gas Dryer Model DBVH512GF1WW began to heat for only a short amount of time so drying clothes took WAY too long. Read online that the first thing to replace are the solenoids. Bought the two solenoids from AppliancePartsPros.com for about $50 total, and it seems to have fixed the problem. Had to watch a few videos to learn to disassemble the dryer, and the job took a couple of hours, but now that I know what I'm doing it could be done in less than 30 minutes. Also, the old solenoids tested... Read more

Ordered replacement part, it shipped really fast. Part was exactly the right thing. Unscrewed 2 screws and pulled some slack out the wires. Disconnected the wire clips. Repeated steps to put in new part. Worked like a charm! Read more

Replaced the igniter Read more

No tools necessary. Simply pull the old gasket free and install new one using the small metal clips in the gasket. Took less than five minutes. Easy. Read more

I watched a video on this web site, which was great. Just had to familiarize myself where the parts are on my stove. It took longer than a pro, but I didn't have to pay for a service call and the parts were cheaper, too. It was just a bit more difficult than changing a light switch. Read more