General Electric Refrigerator Gasket & Seal

Refrigerator evaporator foam pad cover insulates and protects the evaporator coil. Replace if torn, compressed, or missing to maintain efficiency.

Replace your refrigerator's freezer light gasket to restore proper sealing around the light assembly. Prevents air leaks and frost buildup. Verify fit.

Seals the vegetable drawer cover to maintain proper humidity and freshness. Replace if cracked, torn, or causing moisture loss. Verify fit with your model.

Foam gasket block seals gaps in your refrigerator to maintain temperature efficiency. Replace if worn, compressed, or causing air leaks. Confirm fit with your model number.

Seals the evaporator drain pan cover to channel condensation properly and prevent leaks. Replace if you notice moisture buildup under your unit or a loose pan cover fit. Confirm compatibility with your refrigerator model before ordering.

Seals the rear edge of your refrigerator's drain pan to prevent water leaks underneath the appliance. Replace when worn or cracked to restore watertight fit.

This self-adhesive foam strip seals gaps and cushions components to reduce drafts, noise, and moisture intrusion—helpful for restoring proper airflow and improving efficiency where foam padding or gap sealing has deteriorated. What it does:

• Provides a soft seal to close small gaps and prevent air leaks
• Cushions panels to reduce vibration and rattling noises
• Helps limit moisture and dust entry around seals and components
• Supports consistent temperature by reducing unwanted airflow

• Clean and dry the mounting surface before applying for best adhesion.
• Trim to length with scissors or a utility knife; press firmly to set adhesive.
• Avoid stretching the foam while applying; allow adhesive to set 24 hours for full bond.
• If near electrical components, disconnect power before working and avoid covering vents.

Refrigerator door foam tape seals gaps and reduces noise between door components. Replace if worn, compressed, or causing air leaks. Verify fit with your model.