General Electric Refrigerator Housing Or Cover

Replaces the evaporator fan orifice housing that directs airflow in your refrigerator's freezer section. Needed when original is cracked or worn.

Replaces the outer housing that supports your refrigerator's ice crusher and dispenser chute. Order a new housing if yours is cracked or broken.

Replaces a cracked or broken ice auger motor boot housing in your refrigerator's dispenser. Installs inside the ice bin to enclose the auger motor assembly.

Refrigerator evaporator fan motor housing that mounts behind the freezer back wall. Replace if cracked, broken, or damaged to properly secure the fan motor.

This is the orifice plate that mounts around the evaporator fan motor, directing airflow through the evaporator coil area. It helps channel cold air efficiently from the evaporator into the refrigerator and freezer compartments. Replace this part if it is cracked, warped, or damaged, which can lead to uneven cooling or frost buildup in the freezer section.

Replace your refrigerator's temperature control housing if it's cracked, broken, or missing. This cover protects the control mechanism inside your fridge.

Replace a cracked or broken bottom evaporator cover in your 36-inch refrigerator. Protects internal components and directs airflow for consistent cooling.

Replace your refrigerator's control housing cover if cracked, broken, or missing. This protective cover installs over the control panel assembly.

This lower interior light housing assembly replaces a cracked or damaged refrigerator lower light housing and restores the light fixture mounting and lens for proper illumination of the fresh-food compartment. What it does:

• Replaces the lower interior light housing and lens assembly to secure the light and lens in place
• Restores proper alignment and protection for the lower refrigerator light
• Helps stop rattling or movement caused by a broken housing
• Addresses symptoms like a loose or missing lens, exposed bulb, or improper light positioning

• One lower interior light housing assembly (housing with lens as shown)

• Disconnect power to the appliance before starting any repair
• Remove the existing housing carefully to avoid damaging the bulb or wiring
• Retain or reuse the original bulb unless explicitly replacing it
• Use proper fasteners and alignment tabs;

Replaces the molded cover that secures and protects your refrigerator's dispenser area. Needed when the original housing is cracked, broken, or missing.

Outer cover for refrigerator dispenser assembly. Replaces cracked, broken, or missing housing shield. Protects internal components and restores clean appearance.

Plastic cover that protects and directs airflow around the refrigerator condenser coils. Replace if cracked, broken, or missing to shield components.

Replaces cracked or missing light shield and housing in your refrigerator's fresh food compartment. Restores proper illumination and protects bulb. Verify fit.

Mounts and directs airflow for the condenser fan. Replace if cracked, damaged, or broken to restore secure fan mounting and proper airflow direction.

Replace your refrigerator's control housing cover if it's cracked, broken, or missing. This protective cover installs over the control panel assembly.