General Electric Refrigerator Insulation, Sound Dampening Parts

This self-adhesive foam strip provides a thin, flexible seal used to fill gaps, reduce vibration, and block drafts or moisture around appliance components. It restores a close fit and helps reduce energy loss and noise. What it does:

• Seals small gaps between panels or trim to reduce drafts and moisture intrusion
• Dampens vibration and rattling from loose or misaligned parts
• Helps prevent dust and debris from entering sensitive areas
• Supports proper airflow by reducing unwanted leaks that can affect cooling

• Clean and dry mating surfaces before applying to ensure adhesive bonds properly
• Trim to fit with scissors or a utility knife; press firmly along the entire length to secure
• For best results, apply at room temperature and allow adhesive to set before reassembling

This lower foam pad cover cushions and seals the appliance's lower access area to reduce vibration and protect internal components. It helps maintain quiet operation and prevents dust or debris from entering sensitive gaps. What it does

• Provides a soft barrier that dampens vibration and reduces noise from moving parts.
• Helps keep dust and debris out of lower openings and cavities.
• Protects edges and components from direct contact and wear.
• Supports proper fit and alignment of the lower access panel.

• Designed for simple replacement; remove the lower access panel to reach the pad area.
• Confirm orientation and full seating of the pad before reattaching the panel to avoid gaps.
• Use basic hand tools as needed and disconnect power before servicing nearby electrical components.
• If adhesive is used, replace with manufacturer-recommended adhesive or fasteners to ensure a secure fit.

This block foam control regulates foam buildup in the appliance chassis, helping manage moisture and detergent residue so the unit runs more reliably and avoids sensor/valve interference. It's a direct-replacement service part. What it does:

• Provides a mounting and control surface to limit foam buildup in the dispenser/chassis area
• Helps prevent foam from reaching sensors, valves, or other components that can cause erratic operation
• Used when repeated foam-related issues, soap oversudsing, or dispenser leakage affect performance
• Matches OEM form and fit to restore the original foam-management function

• One block foam control

• Refer to your service manual for exact removal and replacement steps for safety and proper routing
• Disconnect power before servicing to avoid electrical shock or accidental startup
• Handle carefully to avoid damage to mounting tabs or adjacent components
• Inspect nearby seals, hoses, and dispensers while replacing this part and replace if worn