Ikea Parts

No instructions are included with either piece, which makes installation take more time and care. Tools needed: Small standard flat blade screwdriver, box knife or other knife with at least a 2" long blade, super glue. Remove the old main crisper frame: 1. Remove old main frame by lifting upward and outward. 2. Remove the center rail from the frame. May require bending of the main frame to remove it. 3. Remove the crisper front panel by unsnapping from frame. This is easily done by... Read more

Replaced the defrost thermostat and heater and the refrigerator was working again. Read more

After sliding out the old shelf I removed the middle track from the old shelf & installed it with the new left side track on the new shelf. They basically click in & out. Slid the new shelf assembly in & put meat drawer in place. Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

Ordered replacement parts Read more

Ordered replacement parts Read more

Placed the robber seal Read more

I was repairing my daughter's WDT730pahz0 Whirlpool dishwasher. The bottom dish rack set of wheels was very easy to install. The replacements for the upper set of wheels is different than the originals. In my opinion, the replacements are far superior to the original parts. The problem, as many have pointed out, is that there are no instructions on how to install the new parts. I worked for 15 minutes, attempting to put the pieces together and then install them on the dishrack. That was a... Read more

I bought the listed condenser fan motor for my Maytag refrigerator. Access to the condenser fan is by removing sheet metal screws of bottom panel with 1/4 in. nut driver. Condenser fan is on left side of rear access area. Remove electrical connector by pressing-in connector release tab with thumb fingernail and pulling on connector. Remove three mounting screws with 5/16 nut driver. Work fan out to the right past the compressor. I used a pair of pliers, as a lever, behind the plastic fan blades... Read more

I ordered 1 assembly first and then another broke. so I ordered 2 more and replaced 2 more. The 4th was replaced last summer. I should have ordered 4 and replaced all when the 1st one failed. Read more

Funny, my husband did it. We have a service contract but you know how long that still takes. So he found the part at the bottom of the dishwasher and it had a number on it. He went to your site and and found the part. Yes it was a little cheaper else where like everything else but what the other sites didn't have he said was the video on how to do it. He explained he felt that takes money to produce so the few dollars more were worth it to him and he can be cheap. We had it in two days like you... Read more

I had an appliance repair guy come and he told me it was possibly the vent assembly but if changing it didn't fix the problem it would be the control board next. He felt it was not worth the money to repair because he would have to disconnect everything just to get to the vent on the right rear top of the dishwasher. When i took the DW out thinking i had to buy a new one i saw this part was stuck open and covered in limescale deposits and grime.I ordered the part from appliance pros and payed... Read more

Ordered the replacement Bake Element and installed it. Read more

Replacing the Door Gasket is very easy and will take about 2-3 mins per door. Simply remove the Gasket Retainer (1 screw), and pull off the old Gasket. Install the new gasket by simply pushing the gasket clips into the holes where the old clips came out from. Be sure to start gasket at the first hole either side of the Gasket Retainer and work your way around. Reinstall Gasket retainer. The Door Insulation is a very involved repair, and best to follow specific repair manual instructions. Door... Read more

Ordered a new one. Read more

We bought a new ice guard and installed it. It is working really good now. Read more